Noise suppressor FAQ

Help get rid of noise

By

Crutchfield Writing Team

The Crutchfield writing team is a group of full-time, in-house copywriters who share a passion for consumer electronics. In addition to creating the articles and videos you find in the Research area of the Crutchfield website, these hard-working and talented people write the informational copy for the products on our website and in the Crutchfield catalog. Our writers constantly research the latest products, technologies, and industry trends, so that we can bring you the most helpful information possible.

More from Crutchfield Writing Team

Editor's note: This article has been retired. To get answers to all of your questions about dealing with noise problems in your car, please read our Noise Suppresssion Guide.

» Is it possible to have noise in my stereo even if I don't have a separate amplifier?

» My friend's system has a lot of noise. How do we start to locate the problem?


Q: Is it possible to have noise in my stereo even if I don't have a separate amplifier?

A: It sure is, especially if you have an aftermarket receiver. Because a high-powered aftermarket receiver's circuits are more sensitive than a factory stereo, it may pick up noise from your car. Luckily, this means you should have an easier time finding the cause and fixing it.

One of the easiest tricks that some people overlook is checking your battery fluid. If it's low, top it off with distilled water. If that doesn't take care of the noise, then refer to our diagnostic flowchart to help track down the problem.

back to top

Q: My friend's system has a lot of noise. How do we start to locate the problem?

A: First, disconnect the stereo patch cables (that run to your amp) from the preamp outputs of your receiver. If the noise stops, then you know that the noise is originating from your receiver (or equalizer, if you're using one); if it doesn't stop, the noise is being introduced somewhere between the patch cables and your amplifier (double check your amp's ground). Finding the culprit is a process of checking each component in your system either by elimination or substitution — until the noise stops.

back to top

Find what fits your car

Loading...