Our Product Research Team
At Crutchfield, you'll get detailed, accurate information that's hard to find elsewhere.
That's because we have our own in-house Product Research team — they open the box,
verify contents, check the owner's manual, and record dimensions, features and specs.
We stay on top of new products and technologies to help people make informed choices.
Q-Logic C-Series Q-Form custom kick panels are designed to hold a 2-way component speaker
system consisting of a woofer up to 6-1/2"
and a tweeter (up to 2" diameter). They are fabricated of durable ABS plastic,
color matched to the factory interior colors, and directly replace the factory
kick panels. The positioning and angle of the speakers provide optimum stereo
imaging and staging.
No Grilles: Because no grilles
are included with the Q-Forms, you must use the grilles
supplied with the component system. In some cases, the grille could slightly
overlap the mounting surface for the woofer. In this case the cutout can be made
so any overlap occurs at the back bottom edge where it will not be visible. Note: One of the included
installation guides states that 2 Q-grilles are included. That is not the case
for the C-series Q-Forms.
Compatibility: These Q-Forms
are designed to fit select 1993-2002 Chevrolet Camaros and Pontiac Firebirds,
Trans Ams, and Formulas.
Note: For each specific vehicle, please verify compatibility with the
Crutchfield Car Selector.
Factory Colors: These kick panels match the factory
Flame Red interior trim. The Q-Forms are also available in Medium Beige,
Medium Gray, Black, Medium Neutral, and Graphite.
Installation Overview: You will
need to cut out the mounting holes in the designated areas of the plastic
roll of foam tape is provided for sealing the woofer in the kick panel. The
tweeter can be flush or surface mounted. Giving exact mounting depths is not
possible, since it will depend to some extent on the space available behind the
factory kick panel.
installation of the Q-Forms, you will need to modify the vehicle's original kick
panel/threshold plate by cutting squarely across the panel approximately 1.5
inches forward of the mounting clip on the threshold section.