Features

Overview: The enclosure is a two piece unit consisting of a enclosure made of 5/8" MDF and a "dark gray" colored plastic fascia. The fascia is colored to match the "dark gray" interior found in some 82'-92' Chevy Camaros, Pontiac Trans Ams and Pontiac Firebirds. Two rectangular, 2 1/2" tall, black plastic riser blocks are attached to the bottom of the enclosure; the riser blocks will hold the bottom of the enclosure 2 1/2" off of the storage well floor (overall enclosure height including the riser blocks is 12 1/4").

Wiring: There are two sets of nickel-plated 5-way binding posts (with plastic wire retention nuts) mounted on the rear of the enclosure. The wires supplied to connect the terminal cups to the woofers are terminated at each end with 0.205" female quick slides.

Installation Note: Run speaker wires from amplifier to enclosure. Place enclosure in rear storage well (between rear wheel wells), and permanently secure the enclosure to the vehicle (see note below). Place plastic fascia on box. Connect speaker wire between woofers and terminals. Place woofers on top of   fascia. Run screws through woofers, fascia, and into box. Press grills into fascia.

Mounting: For sonic and safety purposes, Ai Research recommends permanently securing the enclosure to the vehicle. No mounting brackets are included, so, to permanently attach the enclosure to the vehicle, a bracket kit (item 125B702KIT) will be needed or brackets and screws may be purchased from a hardware store. Bracket mounting requires drilling and screwing into the vehicle and enclosure.