Woofer Construction: This MB
Quart Discus Series woofer is equipped with a treated paper diaphragm with an
inverted parabolic polypropylene dust cap and a Santoprene synthetic rubber,
inverted roll surround.
Basket: The DWF304's motor
structure is supported by a high-strength, non-resonant cast alloy basket.
Kapton Voice Coil Former:
Kapton is a highly temperature-resistant, completely non-magnetic plastic foil.
Because it has no affect on the magnetic field, the woofer provides more
precise, distortion-free music reproduction.
Speaker Terminals: This
dual-voice-coil subwoofer has a unique speaker terminal which can accept up to
10-gauge wire. The one-piece terminal block holds the speaker wire in place
using set screws (2mm Allen wrench supplied). A plastic cover protects the
terminal strip from unwanted contact.
Wiring: The woofer can be
connected in the following ways:
- Standard: You can connect
the woofer to two separate amplifier channels, and each channel will see a
4-ohm load. Connections are made to the woofer's +1, +2, -1, and -2
- Parallel: You can connect
the woofer to a single amplifier channel which will see a 2-ohm load.
Connections are made to the woofer's +1, and -2 terminals. Two supplied
short terminal jumpers are attached to the terminal block to link together
the two positive terminals and the two negative terminals.
- Series: You can connect
the woofer to a single amplifier channel which will see an 8-ohm load.
Connections are made to the woofer's +1, and -2 terminals. The supplied long
terminal jumper is attached to the terminal block to link together the +2
and -1 terminals.
Logo Badge: The self-adhesive
MB Quart Discus Logo badge can be mounted on the top of the screw cover ring in
Enclosure Recommendation: MB
Quart recommends a sealed enclosure with an internal volume of 0.95 cu.ft. for
Mounting Recommendations: The
DWF304 can only be top-mounted into the enclosure. The supplied self-adhesive
rubber gasket should be placed on the woofer to ensure a tight seal. No mounting
hardware is included, however, MB Quart recommends M5 hex-head screws and lock
nuts. After installation, the supplied screw cover ring can be fitted to the
woofer's outer ring for a custom look.
- Power Handling: 400 watts RMS
(200 watts per voice coil)
- Mounting Height: 0.266"
without cover ring, 0.498" with ring installed
Our Product Research Team
At Crutchfield, you'll get detailed, accurate information that's hard to
find elsewhere. That's because we have our own in-house Product Research
team. They verify what’s in the box, check the owner's manual, and record
dimensions, features and specs. We stay on top of new products and technologies
to help people make informed choices.