Matched Amplifier: The CSW200 requires and
is designed to only be used with the Polk SWA500 Subwoofer amplifier (107SWA500, sold
separately). The SWA500 comes with a SPEX Card that configures the EQ,
crossover, and power control circuitry to match the CSW200 subwoofer.
The CSW200 features a long-throw 10" fiber cone woofer with a rubber surround.
The CSW200 has rigidly
braced MDF enclosure construction for low resonance and rattle-free performance.
The enclosure feature and integrated slot vent for deep, driving bass.
The CSW200 subwoofer has two sets of spring post terminals that will accept pin
connectors and bare wire. There is one set on each end for convenience. When
connecting the CSW200 to
the SWA500 amplifier, you can only use one set of terminals - do not connect
Mounting Location: The CSW200
is designed to be mounted between floor or ceiling joists. The CSW200 can fit
between the tighter joist-spacing of QuietFloor or wooden I-Beam construction.
Mounting Brackets: The supplied
brackets and wood screws allow you to mount the CSW200 to any parallel floor or
Isolation Pads: When the
enclosure is installed, it fits snugly against one of the floor or ceiling
joists. To prevent rattling, two of the isolation pads should be installed
between the enclosure and the joist, while the third isolation pad should be
placed on the front panel of the enclosure.
Optional Grille: The CSW200 is
designed to fire through an opening in the floor or ceiling. Once the
installation is complete, the opening can be covered with an optional grille.
The CSW200 is compatible with standard 12" x 12", 10" x 10", or 8" x 14" HVAC
Our Product Research Team
At Crutchfield, you'll get detailed, accurate information that's hard to
find elsewhere. That's because we have our own in-house Product Research
team. They verify what’s in the box, check the owner's manual, and record
dimensions, features and specs. We stay on top of new products and technologies
to help people make informed choices.