Our Product Research Team
At Crutchfield, you'll get detailed, accurate information that's hard to find elsewhere.
That's because we have our own in-house Product Research team — they open the box,
verify contents, check the owner's manual, and record dimensions, features and specs.
We stay on top of new products and technologies to help people make informed choices.
Overview: The Axxess XSVI-6502-NAV replacement OEM radio
interface allows you to install an aftermarket radio in select Chrysler, Dodge,
Jeep, and Mitsubishi vehicles. In these vehicles, there are no 12-volt accessory
wires in the factory harness, which requires the installer to run an accessory
wire to the fuse box or underneath the steering column when installing an
aftermarket radio. The XSVI-6502-NAV is designed to provide a 12-volt, 10-amp
switched accessory output (red wire), along with a dimmer wire (orange/white
Note: Please consult the
Crutchfield Car Selector to see if your vehicle and aftermarket headunit
Navigation Ready: The XSVI-6502-NAV provides essential wires required
for aftermarket radios that have navigation. VSS (Vehicle Speed Sense), Reverse,
and Parking Brake wires are provided. This helps to cut down the installation
time, since the installer does not have to look for these wires in the vehicle.
Retained Accessory Power (R.A.P.): The Retained Accessory Power (R.A.P.) function supplies power to the
radio after the ignition is shut off until one of the front doors are opened.
This function is retained by the XSVI-6502-NAV interface.
OEM Steering Wheel Control Compatible (optional): The XSVI-6502-NAV
interface features a right-angle 3.5mm connector that lets you keep your
vehicle's OEM steering wheel controls via the optional Axxess Steering Wheel
Control Interface (120ASWC1,
Note: The Axxess ASWC steering wheel control interface supports the following aftermarket headunit
manufactures - Pioneer, Sony, Alpine, Kenwood, Eclipse, JVC, Clarion, Dual,
Jensen, Visteon, and Valor. The aftermarket headunit must have a SWC
(Steering Wheel Control) 3.5mm input.
Vehicle Compatibility: The XSVI-6502-NAV replacement OEM radio
interface module is compatible with the following Chrysler, Dodge, Jeep, and
Note: The XSVI-6502-NAV interface is designed to be used in
Chrysler, Dodge, Jeep, and Mitsubishi vehicles without a factory
amplified sound system or when replacing the entire factory amplifier
system. The XSVI-6502-NAV does not retain your vehicle's factory
Color Codes: Wiring up the XSVI-6502-NAV is like wiring up any other
wire harness that would attach to an aftermarket radio's harness. The Metra/EIA
wire code can be found on the back of the interface's package that will aid you
in the wiring of your aftermarket radio The XSVI-6502-NAV interface contains the
following wire leads.
||Right Front +
||Right Front -
||Left Front +
||Left Front -
||Right Rear +
||Right Rear -
||Left Rear +
||Left Rear -
||VSS (Vehicle Speed Sense)