Metra 70-1618 Receiver Wiring Harness

This vehicle-specific wiring harness makes connections between your new car stereo and your car's electrical system.

First, attach the color-coded wires on your Crutchfield-supplied harness to the wires from your new stereo. If you're not using a soldering iron, we recommend that you purchase some wire connectors to secure the connections. Check out our handy article on three ways to connect the wiring harness here.

Now, once this harness is connected to your new stereo, you'll be able to plug right into your car's factory radio connector. This harness saves installation time since you won't have to cut factory wires individually, and this also enables you to re-install the factory radio if needed. A detailed instruction sheet comes with the harness. Warranty: 60 days.

Please read this important note: This harness may not contain provisions for every wire needed to complete your installation, and it will not accommodate special navigation, video, or factory steering wheel control connections. You will need a special adapter if you want your factory steering wheel audio controls to work with your new stereo.

Connections:

Note: The 12V switched power lead may not be present in your car. If not, and your receiver requires a switched 12V lead (most do), run a wire to an appropriate fused switched circuit. This harness does not include rear speaker wires. It may be necessary to either splice your receiver's rear speaker wires to existing wires (if present), or run new rear speaker wires if you want to use rear speakers. See "Accessories" for speaker wire.