About the Rosen DP-1032
Safety in tight spots
Add an extra measure of safety when you're backing up in tight spots. The DP-1032 backup sensor kit connects to your Rosen or Car Show navigation receiver, and alerts you when an object gets too close to the back of your vehicle. The kit includes four sensors, a wiring harness, an interface for your navigation receiver, a 24.5' cable, and a special drill bit to help with the installation. Warranty: 1 year.
What's in the box:
- Main sensor module (with attached 7" cable terminated by a proprietary multi-pin connector)
- 24.5' Connector cable (with a proprietary multi-pin connector on each end)
- 4 Sensors (with attached 8' cable terminated by a proprietary 2-pin connector)
- 8" Camera/Radar harness
- 3/4" Metal hole-saw bit
- Installation Guide
Customer reviews for Rosen DP-1032
Loading...
Loading reviews...
Thanks for submitting your review
Customer photos
This review was collected as part of a promotion
Pros:
Cons:
More details on the Rosen DP-1032
Product Research
Features
Overview: The Rosen Backup Sensor Kit (DP-1032) is compatible with select Rosen & Car Show Multimedia Navigation head units. The Rosen Backup Sensor Kit includes a hideaway sensor module, a 24.5' connector cable, exterior sensors, and a rear-camera/radar input harness. The rear-camera/radar input harness plugs into the back of the Rosen or Car Show Multimedia Navigation head unit in order to plug in the included sensor module and optional rear-view camera (135DP1068, sold separately). The hideaway sensor module is mounted inside the vehicle and connected to your Rosen or Car Show Multimedia Navigation head unit using the supplied 24.5' connector cable. The 4 exterior sensors plug into the hideaway module and are mounted outside the rear of the vehicle (symmetrically on the bumper surface). Once installed, the Rosen Backup Sensor Kit will send an audible warning through your vehicle's audio system, if your vehicle backs up to close to an object.
Sensor Mounting: The Rosen Backup Sensor Kit comes supplied with a 3/4" metal hole-saw bit that attaches to a cordless or electric drill (not included) to cut out openings for the 4 exterior sensors in your vehicle's bumper. Once these holes are cut-out in your vehicle's bumpers, the exterior sensors clip into place. When installed, the sensor should point straight back, not to the sides, up, or down.
Dimensions:
- Hideaway Sensor Module: Width = 4.9375", Height = 1.125", Depth = 3.1875"
- Exterior Sensors: Diameter = 0.875", Depth = 1.0"
The Rosen DP-1032 replaces these items
Rosen DP-1030
- backup sensor kit for Rosen navigation receivers
- includes four sensors, wiring harness, interface, and drill bit
Loading...
Loading accessories...
Customer Q&A
1 question already asked
Loading...
Loading articles...