CEA-2006 Compliant: CEA-2006 is a system of testing and
measurement methods for mobile audio amplifiers. This voluntary standard advocates
a uniform method for measuring an amplifier's RMS power output and signal-to-noise
ratio. The criteria for measuring power uses a DC input voltage of 14.4 volts and
the RMS power output is measured into a 4Ω load, with 1% or less Total Harmonic
Distortion plus noise (THD+N), and over a frequency range of 20 Hz to 20 kHz (for
full range amplifiers). Signal-to-Noise ratio is measured in weighted absolute
decibels (dBA) at a reference of 1 watt into 4Ω. CEA-2006 standards allow
consumers to compare amplifiers on an equal basis. Using CEA-2006 criteria, the
Sony XM-N1004 is rated at 70 watts RMS x 4 channels, with a 93 dBA signal to noise
Pulse Power Supply: The amplifier utilizes a Pulse Power
Supply system to regulate the fluctuating voltage received from the car's
Crossover: The front and rear amps have independent crossovers:
- Front: a three position switch
sets crossover to low pass, off (full range), or high
pass; the crossover point is fixed at 80 Hz and the
slope is 18 dB/octave when set to low pass, 12 dB/octave
when set to high pass
- Rear: a two position switch turns
the low pass filter (LPF) on/off; the crossover point
is fixed at 80 Hz and the slope is 18 dB/octave
Power Connections: The power, ground, and remote turn-on
screw terminals are 0.35" wide. A Phillips-head or flat blade screw driver
(not included) is required to tighten/loosen the terminals. A protective cover
is included for the power/ground/remote terminal block.
Speaker Connections: The speaker screw terminals are 0.35"
wide. A Phillips-head or flat blade screw driver (not included) is required to
tighten/loosen the terminals.
RCA Input: The amplifier has two pair of stereo RCA line
level inputs (front left/right and rear left/right).
Fuse: The amp is protected by two 25-amp ATO blade fuses.
Our Product Research Team
At Crutchfield, you'll get detailed, accurate information that's hard to
find elsewhere. That's because we have our own in-house Product Research
team. They verify what’s in the box, check the owner's manual, and record
dimensions, features and specs. We stay on top of new products and technologies
to help people make informed choices.