Build a system around your factory radio
AudioControl's LC6i processor allows you to add aftermarket amps, speakers, and subs to your factory radio, so you can enjoy better sound without losing factory features. It accepts speaker-level signals from your factory radio or amplifier, so you can use it with any system.
Inputs and outputs
The LC6i features six speaker-level inputs that let you connect amplified signals, including multi-wire cables from Bose® and other premium factory systems up to 400 watts. The LC6i sums all the signals you send it, even if they're actively crossed over by your factory system, so you get a strong, full-range signal for your processors and amps. The LC6i features six RCA preamp outputs that'll handle the traditional front/rear/sub setup.
Level matching is a breeze
AudioControl couldn't make it much easier to set up your system. Just set your factory stereo to about 3/4 of its maximum volume, and turn the output level control of the LC6i until the "Maximized" light begins to flicker. Adjust the gain controls on your amps and you're done. You've just matched your levels, so you can count on getting maximum performance and minimum noise from your amp setup.
The optional dash-mount subwoofer controller allows you to adjust the level of your sub channel on the go. The speaker-level inputs sense incoming signals and turn on the LC6i, while a built-in 12-volt trigger tells your amps or other gear to turn on.
Information provided by AudioControl