Our Product Research Team
At Crutchfield, you'll get detailed, accurate information that's hard to find elsewhere.
That's because we have our own in-house Product Research team — they open the box,
verify contents, check the owner's manual, and record dimensions, features and specs.
We stay on top of new products and technologies to help people make informed choices.
The BTA6250D features a water-resistant poly enclosure that houses a
6-1/2" poly woofer with a foam surround. The woofer is powered by a built-in
120-watt digital amplifier. The patented Bass Tube enclosure design eliminates bass
standing waves for high accuracy, and superior efficiency.
Low-pass Filter: The BTA6250D
has a low-pass filter that can be adjusted from 60 to 250 Hz.
Control: Using an optional remote control, you can control the bass
output level and crossover frequency of the subwoofer from a remote location.
Level Control: There is a
rotary control on the rear-panel that allows you to adjust the level of the subwoofer.
Crossover Control: The
unit's rotary control is found on the rear-panel and allows you to adjust the low-pass filter from
60 to 250 Hz.
Power LED: If power, ground and remote are connected properly, the LED on back of the unit will illuminate in green.
Phone-type jack for use with an optional remote control;
found on rear-panel.
Power Harness: Two
quick-slides for use with supplied power harness; found on rear-panel.
Signal Harness: 14-pin
Molex plug for use with supplied signal harness
mounting strap has an attached mounting base that can be secured to your vehicle
using the supplied self-tapping screws. Once the mounting bases are installed,
the tube is held in place by the mounting straps. For best results, the tube
should be mounted facing into a corner, and there should be 2" to 4" between the
woofer and the corner into which the woofer is pointing.
Power Wire: the 12-gauge power lead is
only 11" long, so additional wire is required to extend it to the battery.
Additional power wire must be crimped or soldered to the Bazooka's power
Ground Wire: the 12-gauge ground lead
is also only 23" long, and may need to be extended. Additional ground wire
must be crimped or soldered to the Bazooka's ground lead.
Speaker Wire: required only when using
the high-level inputs
Patch Cord: required only when using
the low-level inputs
Remote Turn-on Wire: required to connect the remote turn-on lead to the amplifier turn-on lead of your radio