Overview: The BTA8250D features a water-resistant poly enclosure
that houses a 8" poly woofer with a foam surround. The woofer is powered by a
built-in 160-watt digital amplifier. The patented Bass Tube enclosure design eliminates
bass standing waves for high accuracy, and superior efficiency.
Additional Sub: A second passive Bazooka tube can be added
to the system (item number
204BT8014, sold separately), and powered by the amplifier built into the
BTA8250D. The included signal harness has speaker output wires.
Low-pass Filter: The BTA8250D has a low-pass filter that can be
adjusted from 60 to 250 Hz.
Remote Level/Crossover Control: Using an optional remote control
204RBCM250, sold separately), you can control the bass output level and
crossover frequency of the subwoofer from a remote location.
Level Control: There is a rotary control on the rear-panel that
allows you to adjust the level of the subwoofer.
Crossover Control: The unit's rotary control is found on the
rear-panel and allows you to adjust the low-pass filter from 60 to 250 Hz.
Power LED: If power, ground and remote are connected properly,
the LED on back of the unit will illuminate in green.
Remote Control: Phone-type jack for use with an optional
remote control; found on rear-panel
Power Harness: Two quick-slides for use with supplied power
harness; found on rear-panel
Signal Harness: 14-pin Molex plug for use with supplied signal
Installation: Each mounting strap has an attached mounting base
that can be secured to your vehicle using the supplied self-tapping screws. Once the
mounting bases are installed, the tube is held in place by the mounting straps. For
best results, the tube should be mounted facing into a corner, and there should be
2" to 4" between the woofer and the corner into which the woofer is
- Power Wire: The 12-gauge power lead
is only 11" long, so additional wire is required to
extend it to the battery. Additional power wire must be
crimped or soldered to the Bazooka's power lead.
- Ground Wire: The 12-gauge ground lead
is also only 23" long, and may need to be extended.
Additional ground wire must be crimped or soldered to the
Bazooka's ground lead.
- Speaker Wire: required only when using
the high-level inputs
- RCA Patch Cord: required only when using
the low-level inputs
- Remote Turn-on Wire: required to connect
the remote turn-on lead to the amplifier turn-on lead of your
Our Product Research Team
At Crutchfield, you'll get detailed, accurate information that's hard to
find elsewhere. That's because we have our own in-house Product Research
team. They verify what’s in the box, check the owner's manual, and record
dimensions, features and specs. We stay on top of new products and technologies
to help people make informed choices.