Radio Replacement Interface for Toyota & Lexus: The CRUX SWRTY-61J is a radio replacement
interface for select 2003-2011 Toyota vehicles with factory JBL amplifiers. It facilitates the
integration of select aftermarket radios to enable retention of certain factory
features when replacing a factory-installed radio. This enhanced interface
retains the factory JBL amplifiers, aux input, and is also pre-programmed for
retention of steering wheel controls.
Note: This CRUX adapter will only retain steering wheel audio controls with car
stereos made by Pioneer, Sony, Jensen, Alpine, Clarion, Kenwood, JVC, and Blaupunkt.
Vehicle Compatibility: The CRUX SWRTY-61J is supported by
the following Toyota & Lexus vehicles; with factory JBL amplified systems
(as of 10/8/2014).
Note: Please consult Crutchfield's
Outfit My Car to see if your vehicle is compatible and what additional
installation accessories will be needed.
Supported Aftermarket Head Units: The CRUX SWRTY-61J radio replacement
interface will only retain steering wheel audio controls with car
stereos made by Pioneer, Sony, Alpine, Clarion, Kenwood, JVC, and Blaupunkt.
Factory JBL Amplifier: The CRUX SWRTY-61J retains your
vehicle's factory JBL amplifier system and fading capability from the
aftermarket head unit. You aftermarket stereo will need to have 4-channel
Steering Wheel Control Compatible: The CRUX SWRTY-61J
features a steering wheel control output for compatible aftermarket head units.
The steering wheel control output consists of a right-angle 3.5mm connector and
a light blue/yellow wire (use the connection that your aftermarket head unit is
fitted with). The SWRTY-61J interface module will work with any of the listed
aftermarket head units, by setting its three dip-switches (see owner's manual
for appropriate setting).
Note: The steering wheel control interface features two
4-pin connectors (labeled - "Pioneer/Sony" and "Alpine/Clarion/Kenwood/JVC").
You will only plug in one of these connectors to the interface module, based
on the type aftermarket head unit you are installing.
Auxiliary Input Retention: For select 2007 up vehicles, you get to keep the factory auxiliary (3.5mm) input. The
included harness contains male stereo RCA connectors which plug into your
aftermarket head unit's rear-panel Aux input. If your aftermarket head unit
contains a 3.5mm Aux input, then you will need a female stereo RCA to male
stereo minijack adapter cable (sold separately).
Wiring Harness: The included harness features the following
wires which will need to be hardwired (solder or crimped) to your aftermarket
head unit's wiring harness.
||+12 Volt Accessory
||+12 Volt Constant
|White RCA Leads
||Left Front Speakers
|Gray RCA Leads
||Right Front Speakers
|Green RCA Leads
||Left Rear Speakers
|Purple RCA Leads
||Right Rear Speakers
Note: Installation tools, hardware, & accessories are not
included & sold separately.
Our Product Research Team
At Crutchfield, you'll get detailed, accurate information that's hard to
find elsewhere. That's because we have our own in-house Product Research
team. They verify what’s in the box, check the owner's manual, and record
dimensions, features and specs. We stay on top of new products and technologies
to help people make informed choices.