At Crutchfield, you'll get detailed, accurate information that's hard to find elsewhere.
That's because we have our own in-house Product Research team — they open the box,
verify contents, check the owner's manual, and record dimensions, features and specs.
We stay on top of new products and technologies to help people make informed choices.
Features
Connections, Controls and
Indicators
Specifications
Features
8 Outlets: The Panamax M8-HT-PRO Power Conditioner features
four balanced double "L" filtration circuit AC outlets and four high current AC
outlets.
Premium Filtration: The Panamax M8-HT-PRO's Power Cleaning and Linear
Filtration eliminates common symptoms of contaminated power (including loss of
detail, pops, hisses, hums and visual artifacts) and allow your A/V equipment to
perform up to its full capability.
Automatic Voltage Monitoring (AVM): The M8-HT-PRO senses sustained
voltages that are high enough to cause damage to your components, and shuts the
power down before damage can occur to your equipment.
Cross Contamination Reduction The M8-HT-PRO is designed to provide noise isolation between
the two isolated outlet banks so that any noise created by an A/V component in one bank cannot contaminate the
power to the equipment that is plugged into the other outlet bank.
12 Volt Trigger: The unit's
12 Volt Trigger port allows source equipment to activate or deactivate outlets
5-8 on the M8-HT-PRO.
Coax Protection: The M8-HT-PRO features three sets of threaded coaxial
inputs and outputs to protect equipment from electrical surges that travel over
Cable, Satellite, and Antenna lines.
Hi Definition Ready: The Panamax M8-HT-PRO
has been designed to work with your High Definition system. the M8-HT-PRO's
coaxial protection circuits achieve optimum signal quality that have the less
than 0.5dB of attenuation from 5MHz to 2GHz. The upgraded coaxial protection has
been specifically designed to virtually eliminate signal loss. The clamping
level 75 V will meet the demands of both cable and satellite voltage while
minimizing exposure to damaging spikes and surges.
Telephone/LAN Line Protection: The M8-HT-PRO is equipped
with a RJ-45
telephone/LAN jack input and output which protects equipment from electrical surges
that travel over Telephone and network lines.
Surge Protection:
The M8-HT-PRO features exclusive protect and
disconnect circuitry to prevent damage to your equipment in the event of a
catastrophic surge such as lightning by completely disconnecting AC power to
connected equipment.
Lifetime $5,000,000 Connected
Equipment Warranty: Panamax will replace or repair equipment that is damaged by an AC
or signal line surge while connected to a properly installed Panamax surge protector
(up to $5,000,000).
Mounting: The M8-HT-PRO can be placed on a flat surface or
mounted to your wall using the unit's integrated keyhole slot and attached wall
bracket.
Connections,
Controls and Indicators
AC Outlets:
- 1-4 AC Outlets: four
balanced double "L" filtration AC outlets
- 5-8 AC Outlets: four
high current AC outlets
Input/Output:
- SAT/CATV Input/Output (1, 2, 3):
3 sets of gold-plated input/output
universal threaded coax terminals
- Telco/LAN Input/Output:
RJ-45 input and output jack for connecting
either a telephone or LAN line
- DC Trigger: DC trigger
for high current outlets
Controls:
- Power/Reset: On/off
power switch and circuit breaker combo
Indicators:
- Power On Protection OK:
this LED illuminates green to indicates that the surge protector is
functioning properly and that all connected equipment is protected
- Ground OK: this LED
illuminates green to indicate that the wall outlet is properly wired and
grounded
- Unsafe Voltage: this
LED flashes red to indicate that incoming voltages are unsafe and the surge
protector has disconnected the power to your connected equipment
- DC Trigger: this LED
illuminates green to indicate whether or not a 12VDC signal is being
received from another component
Specifications
AC Power:
- Line Voltage: 120VAC, 50/60Hz
- Initial Clamping Level: 200V Peak, 141V RMS
- UL 1449 Suppression Rating: 330V
- Protection Modes: L-N, L-G, N-G
- Maximum Current Rating: 15A
(1800W)
- Energy Dissipation:
1875 Joules
- Peak Impulse Current: 65,000 A
- EMI/RFI Noise Filtration: 53dB (100kHz-1MHz)
- Response Time: <1n
LAN Protection:
- Compatibility:
10/100bT
- Clamping Level: 7V
- Suppression Modes:
Differential and Common Ground
- Wires Protected: Pins
1, 2, 3, 6
- Connectors: RJ-45
Telco Protection:
- Clamping Level: 260V
- Capacitance: 30pF
- Suppression Modes: Metallic
and Longitudinal
- Wires Protected: 2 wire, 1 pair (4,5)
- Connectors: RJ-45
Universal Coax Protection:
- Clamping Level: 75V
- Frequency Range:
5MHz-2GHz
- Insertion Loss: <0.5dB
- Connections: "F"-type
