About the Lightning Audio LA-4i
Power your amp and feed it signal
Lightning Audio's LA-4I 4-gauge wiring kit allows you to send power and signal to an amplifier in your car audio system safely. Along with the heavy-duty 4-gauge power and ground cables, this kit includes a 17-foot 2-channel RCA patch cable for getting the signal from your car receiver to your amp, a 20-foot remote lead, a ANL fuse holder with 80-amp fuse, and assorted hardware. All you need is speaker wire (sold separately) to complete your amp install.
Product highlights:
- amplifier wiring kit
- 20' 4-gauge red power wire
- 3' 4-gauge gray ground wire
- 20' 18-gauge turn-on lead blue
- 17' 2-channel RCA patch cable
- ANL fuse holder with 80-amp ANL fuse
- 2 ring terminals, 2 spade terminals, a firewall bushing, and 10 cable ties
- warranty: 1 year
- MFR # LA-4I
What's in the box:
- 20' Length of 4-gauge power wire (red jacket)
- 3' Length of 4-gauge ground wire (dark gray jacket)
- 20' Length of 18-gauge remote turn-on wire (blue jacket)
- ANL fuse holder
- 80 amp ANL fuse (installed)
- 17' Stereo RCA patch cord
- 1 Plastic grommet
- Ten 5" wire ties
- One 7/16" crimp-on ring terminal (red sleeve)
- One 5/16" crimp-on ring terminal (black sleeve)
- Two 3/8" wide crimp-on spade terminals (one with red sleeve/one with black sleeve)
Customer reviews for Lightning Audio LA-4i
Loading...
Loading reviews...
Average review:
4.5 out of 5 starsThanks for submitting your review
Customer photos
This review was collected as part of a promotion
Pros:
Cons:
More details on the Lightning Audio LA-4i
Product Research
Features
Single Amplifier 4-AWG Kit: This kit includes the following:
- One 20' length of 4-gauge power wire
- One 3' length of 4-gauge ground wire
- One 20' length of 18-gauge remote turn-on lead
- 17' twisted pair stereo RCA patch cord
- ANL fuse holder
- 80 amp ANL fuse (installed)
- One 2/3" wide, 7/16" diameter crimp-on positive ring-terminal (red sleeve)
- One 5/8" wide, 5/16" diameter crimp-on negative ring-terminal (black sleeve)
- Two 3/8" wide, crimp-on spade terminals (one with a red sleeve, the other a black sleeve)
- One plastic grommet
- Ten 5" wire ties
Fuse Holder: The fuse holder requires a 4mm Allen wrench to secure the input and output wires and 5mm Allen wrench to change the fuse. There are four holes in the base for mounting and the dimensions are approximately:
- Length: 6" (without adding for the wires)
- Height: 1-3/4"
- Width:
- Main Body: 1-3/8"
- Base: 2-1/4"
Loading...
Loading accessories...
Customer Q&A
1 question already asked
Loading...
Loading articles...
This is a very nice kit. All i needed to add was the speaker wire. I had a lot of left off wire and accessories from the kit which may come in handy later.
Swift from Colorado Springs, CO