Alpine MRP-F600

V-Power Series 4-channel car amplifier
100 watts RMS x 4

  • Alpine MRP-F600


  • Alpine MRP-F600

Crutchfield OMC logo
We don't check this item for fit or compatibility.
Item #: 500MRPF600

Review Summary

This item is no longer available to purchase.
Contact us for other options
Call   Email  

Our take on the Alpine MRP-F600

by Buck Pomerantz

My system has plenty of power. Who needs an amp?

You might think you don't need an amp because you have a 400-watt system in your car, or because your new stereo puts out 50 watts a channel. But those are peak wattage ratings, which may boil down to 15 or 20 watts per channel, using the more realistic RMS rating. An amp sends your speakers the power they need to deliver your music with clarity and impact, whether you're using factory speakers or high-performance components. And low-frequency reproduction requires lots of power, so an amp is an absolute must if you're adding a sub to your system.

Alpine Authorized Online Dealer

V-Power amplifiers deliver the sound quality that made Alpine famous. Highly efficient power supplies housed in sleek black casings guarantee that these amps stand out in performance and appearance. The thermal management system dissipates heat and saves power, so your V-Power amp will run reliably for years to come.

The MRP-F600 4-channel amplifier sends 100 watts RMS to each of your front and rear speakers, or switches to 2-channel mode to power a pair of subwoofers. You can also switch to 3-channel mode, then power a subwoofer with 300 watts RMS while the other two channels power a pair of full-range speakers.

High- and low-pass filters put you in command of the frequencies that reach your speakers, while the bass boost is armed with plenty of low-end punch. Preamp- and speaker-level inputs allow you to connect this amp in almost any vehicle. Let a V-Power amplifier transform the sound of your car's audio system.

See more info on this item


  • 4-channel car amplifier
  • 100 watts RMS x 4 at 4 ohms (150 watts RMS x 4 at 2 ohms)
  • 300 watts RMS x 2 bridged output at 4 ohms (4-ohm stable in bridged mode)
  • 2-, 3-, or 4-channel output
  • variable high-pass/low-pass filters (50-400 Hz, 12 dB/octave)
  • selectable bass boost (12 dB at 50 Hz)
  • subsonic filter (15 Hz, channels 3 & 4 only)
  • MOSFET power supply
  • CEA-2006 compliant
  • STAR Topology (minimizes internal noise and prevents ground interference)
  • speaker- and preamp-level inputs
  • gold-plated screw terminals
  • fuse rating: 25A x 3
  • 4-gauge power and ground leads recommended — wiring and hardware not included with amplifier
  • 15"W x 2-3/8"H x 9-9/16"D
  • warranty: 1 year
  • Our 60-day money-back guarantee

Note: Sorry, Crutchfield cannot ship Alpine products to Guam or Puerto Rico.

Hands-on research from the Crutchfield Labs (what are the Labs?)

Features and Specs
RMS Power Output (Watts x Channels) 100 x 4
Peak Power Output (Watts x Channels) N/A
Power at 2 Ohms (Watts x Channels) 150 x 4
Bridged Power (Watts x Channels) 300 x 2
Minimum Impedance Bridged 4
Minimum Impedance Unbridged 2
Best Frequency Response 20-20k Hz
THD at Rated RMS Power 1%
Signal to Noise Ratio 80 dB
Input Voltage 14.4v
Amplifier Class AB
Low-Pass Crossover Frequency 50-400 Hz
Low-Pass Slope (dB/octave) 12 dB
High-Pass Crossover Frequency 50-400 Hz
High-Pass Slope (dB/octave) 12 dB
Bass Boost 12 dB
Bass Boost Frequency 50 Hz
Fan Cooled No
Fuse Rating 25 x 3
Speaker Level Inputs Harness
Preamp Outputs 1 pair
Width (inches) 9-9/16
Height (inches) 2-3/8
Depth (inches) 15
Parts Warranty 1 Year
Labor Warranty 1 Year
Product Research
What's in the box?

Download owner's manual

  • 4-Channel amplifier
  • Three 25 amp fuses (installed)
  • 8" Speaker-level input harness (8-pin Molex plug on one end and bare wires on the other)
  • 2 Terminal covers
  • 4 Self-tapping mounting screws (M4 x 20mm)
  • 4 Machine screws for securing terminal covers (M3 x 12mm)
  • Owner's Manual (English/French/Spanish)
  • Customer Care Registration card

Our Product Research Team

At Crutchfield, you'll get detailed, accurate information that's hard to find elsewhere. That's because we have our own in-house Product Research team — they open the box, verify contents, check the owner's manual, and record dimensions, features and specs. We stay on top of new products and technologies to help people make informed choices.

Inputs and Outputs


V-Power: Alpine's V-Power series amplifiers offer clean power output, clarity and detail at any volume level, and exceptional reliability. V-Power amplifiers feature rugged heat sinks that ensure optimum temperature and performance for non-stop output. The V-Power amplifiers are ideal for upgrading aftermarket or factory equipment and can be connected to just about any system. RCA and High-level inputs ensure easy installation, while flush mount controls make for an easy set-up. The V-Power amplifier also come with end caps that cover the inputs and connectors to create a clean, finished installation. In addition, variable crossover and Bass EQ functions provide flexible tuning possibilities for your car audio system.

Thermal Management: The amplifier utilizes rugged heat sinks and an extremely sophisticated thermal management processor to continuously monitor the amplifier's temperature, ensure nonstop output and stable, reliable performance.

Gain Controls: This amp has independent front and rear channel gain controls.

Crossovers: Both front and rear channels have independently selectable high-pass and low-pass variable 50-400 Hz crossovers with a slope of 12dB/octave. The crossovers can also be independently turned off for full-range operation.

Subsonic Filter: This amp utilizes a fixed-automatic 15Hz, 18 dB/oct subsonic filter to eliminate super low frequencies that can rob power from your amplifier and damage your speakers.

Bass EQ: The Bass EQ circuit provides a fixed boost of 12dB at 50 Hz for the rear channels only. The Bass EQ does not function when the amp's rear-channel crossover is set to "high-pass" operation.

Inputs: The amplifier offers both line-level and speaker-level inputs for 4 channels. The supplied speaker-level input harness allows you to connect this amplifier to a receiver without preamp outputs; aftermarket or factory.

Line Outputs: This amplifier has a pair of non-fading stereo RCA line outputs. You can use these outputs to daisy-chain another amplifier without having to run additional signal cables from the receiver.

Terminal Cover: The amp comes with two plastic covers that protect and insulates the RCA, power, and speaker connections. Four supplied machine screws attach the cover to the amplifier.

Inputs and Outputs

Left Side Of Amplifier:

  • GND: Gold-plated set screw terminal, accommodates bare wire up to 4 gauge
  • Battery: Gold-plated set screw terminal, accommodates bare wire up to 4 gauge
  • Remote: Gold-plated set screw terminal, accommodates bare wire up to 8 gauge
  • Speaker Outputs: Gold-plated terminal strips for 4 speakers, 0.3125" wide

Right Side Of Amplifier:

  • Line Inputs: 2 pair of gold-plated stereo RCA jacks
  • Line Outputs: 1 pair of gold-plated stereo RCA jacks
  • Speaker Level Input: Molex plug input for supplied 8-pin harness
Review this product
Great Gear Giveaway rewards card

Submit a review and then enter to win a $500 rewards card

Alpine MRP-F600 Reviews

Average Customer Review:

4 people say:

Review this product:

Thanks for taking the time to share your experiences about this product. Please be sure to focus your comments on the product itself. Read our Review Guidelines for more information.

Your email won't be visible. Please use the email address that is associated with your order.
(e.g., JohnD) Your review will be signed using the display name and location
(e.g., Charlottesville, VA)

Click on a star to rate the overall product on a scale of 1-5
1500 characters left
Attach a YouTube Review
Crutchfield Video Review Guidelines
  • Only submit videos that you made or are authorized to use.
  • Do not submit videos that contain music, video or visuals that are copyrighted and belong to someone else.
  • Please see our Review Guidelines for more information.
500 characters left
500 characters left
Filter by rating:
5 out of 5

Alpine MRP-F600

Written By knedler, Honolulu on Friday, February 20, 2009
Crutchfield Customer Review (What's this?)
Ya, I agree with the others...this amp is sweeeet. I had a budget to outfit my Tacoma so I used the F600 to power a pair of Infinity 6020cs 2 ohm components up front and bridged channels 3 & 4 to power a Pioneer TS- SW2541D 10" 4-ohm Shallow Component Subwoofer behind the back seat. I was cautiously optimistic but I was rewarded beyond my expectations...I love this amp!!
4 out of 9 people found this helpful
Was this review helpful?    Yes | No
5 out of 5

clean sound/powerful

Written By James, orlando fla on Friday, September 12, 2008
Crutchfield Customer Review (What's this?)
This amp runs two sets of 5 1/4'-two sets of 4' tweeters,I also have 2 mrp400 alpine amps for 5 1/4',6 1/2',plus two alpine mono mrp400 amps for two rockford fosgate 10' & two rockford fosgate 12'.These alpine amps push 16 speakers at 172 dbs drawings 60 amps current-pure clean power,tight bass no boom boom stuff,ALPINE IS VERY CLEAN PURE POWER,believe me...
12 out of 32 people found this helpful
Was this review helpful?    Yes | No
5 out of 5

Amazing Amp

Written By 19Rocker88, New London, Texas on Monday, August 25, 2008
Crutchfield Customer Review (What's this?)
This amp is Amazing! It Made my infinity kappa perfect 6.1 series sound good!
9 out of 15 people found this helpful
Was this review helpful?    Yes | No
5 out of 5


Written By Bennyboy, Newark, NJ on Wednesday, May 07, 2008
This amp is great! Awesome power, very, very, clean power. Little, too no
distortion. First time I heard my new alpine type S speakers on this new
Alpine amp, I was very, impressed. I had good amps in the pass, but
not like this. Good job, once again Alpine.
47 out of 64 people found this helpful
Was this review helpful?    Yes | No

Add accessories for the Alpine MRP-F600

Bring the music from your amp to your speakers. See all categories & accessories

T-Spec 12-gauge Speaker Wire Black/white jacket — priced per foot
29 people say
Your Price: $1.99
Add to Cart
7 people say
Your Price: $29.99
Add to Cart
T-Spec 2-Channel RCA Patch Cables Available in 7 different lengths (17-foot)
25 people say
Your Price: $19.99
Add to Cart
Pro.Fit Wire Worm Installation tool helps route wiring through tight spaces
31 people say
Your Price: $12.99
Add to Cart
InstallCard: Amp or Equalizer Prepaid professional amplifier or EQ installation
17 people say
Your Price: $79.99
Add to Cart

Why choose SquareTrade?

The #1-Rated Protection Plan

Thousands of people have reviewed SquareTrade Protection Plans — and made us #1.

5-Day Service Guarantee & Free Shipping

We'll repair or replace your item in five business days or less after we've received it, or your plan is free. And, as always, we pay for all shipping.

Protection from Normal, Everyday Use

Repairing your average mechanical or electrical failure can cost as much as buying a new device. With SquareTrade, you're covered — including parts and labor.

3 Year Protection Plan
3 Year Protection Plan
Your Price: $41.99
Add to Cart

For a more in-depth review and enhanced detailed information on the Alpine MRP-F600, please visit the Crutchfield website product page (/ISEO-rccbcspd/p_500MRPF600/Alpine-MRP-F600.html ).