Injection-Molded Woofers: The woofer cones are injection-molded
carbon fiber filled polypropylene. This molding process assures a uniform cone
thickness for superior linearity and clarity. It is also light weight and rigid
for decreased distortion and improved bass response.
Rubber Surrounds: The rubber surrounds dampen unwanted harmonic
distortion while maintaining linear geometry under extreme weather conditions. This
leads to less distortion, superior frequency response, and superior durability.
Phase Plug: Each woofer's billet aluminum phase plug enhances
voice coil cooling.
VAST Surround: The Vertical Attach Surround Technique (VAST)
increases a speaker's effective radiating cone area without increasing the size
of the basket.
FlexFit: The Flex Fit frame utilizes slots (where possible)
instead of single screw sized holes; allowing slight adjustment of the speaker
Klippel Verified: The Klippel distortion analyzer, a device
that uses a laser and sophisticated software to do large-scale analysis of drivers
in motion, lets Rockford Fosgate optimize the speaker's motor structure, voice coil
alignment, and suspension to yield the best possible performance.
Size Classification Note: Some manufacturers, including
Rockford Fosgate, call this size speaker a 6-1/2". Because it requires a
larger cutout than a standard 6-1/2" speaker, Crutchfield has traditionally
referred to this size woofer as a 6-3/4". Please refer to the Crutchfield
Vehicle Selector to confirm fit in your vehicle.
Multi-OEM Adapter: For mounting flexibility, the included
brackets allow installation in 6x9 applications. When using the brackets the
mounting height is 0.611" and the depth is 2.344" (top mount).
Note: The bracket is generic (cutout
sized for a 5-1/4) and requires modification before the
T2652-S will fit into it.
Tweeters: The tweeters are 1" aluminum domes offering
outstanding dispersion and clarity.
Mounting: The tweeters have multiple mounting configurations;
choose flush or surface mount. The Discreet Dual Clamp (DDC) flush mount system
provides concentric clamping pressure around the perimeter of the opening. The
surface mount housing can be positioned at two angles, approximately 15° or 30°
angle. Depending on the mount used, the installed dimensions are:
Tweeter Level: A switch on each crossover allows you to adjust
the output level of the tweeters; -2 dB, 0 dB, or +2 dB.
Tweeter Axis: Another switch on each crossover adjusts the
tweeter output for on axis or off axis placement.
Specifications: The crossover slope is 18 dB/octave high
pass and 12 dB/octave low pass. The crossover point for both is 3 kHz.
Bi-amp: The crossovers have discrete inputs for the woofer
and tweeter, along with a bi-amp on/off switch, so each component can be powered
by an individual amplifier channel. (When using only two amplifier channels,
leave the bi-amp switch off and use the tweeter inputs.)
Wiring: The crossover inputs and outputs are set screw clamps;
they will accept bare wire up to 10-gauge.
- Width: 4-5/8"
- Height: 1-3/8"
- Depth: 4-5/8"