Woven LCP: Much stronger than aluminum, with better damping
qualities, the woven Liquid Crystal Polymer (LCP) fiber woofer cones are light
weight and rigid to decrease distortion and improve bass response.
Butyl Rubber Surrounds: The butyl rubber surrounds dampen
unwanted harmonic distortion while maintaining linear geometry under extreme
weather conditions. This leads to less distortion, superior frequency response,
and superior durability.
VAST Surround: The Vertical Attach Surround Technique (VAST)
increases a speaker's effective radiating cone area without increasing the size
of the basket.
FlexFit: The Flex Fit frame utilizes slots (where possible)
instead of single screw sized holes; allowing slight adjustment of the speaker
Klippel Verified: The Klippel distortion analyzer, a device
that uses a laser and sophisticated software to do large-scale analysis of drivers
in motion, lets Rockford Fosgate optimize the speaker's motor structure, voice coil
alignment, and suspension to yield the best possible performance.
Terminals: In addition to male quick slides, the woofers also
have set screw terminals that will accept up to 12-gauge bare wire.
Size Classification Note: Some manufacturers, including
Rockford Fosgate, call this size speaker a 6-1/2". Because it requires a
larger cutout than a standard 6-1/2" speaker, Crutchfield has traditionally
referred to this size woofer as a 6-3/4". Please refer to the Crutchfield
Vehicle Selector to confirm fit in your vehicle.
Ring Radiator Tweeters: The tweeters use a Ring Radiator
design, similar to those in many audiophile home speakers. The Liquid Crystal
Polymer (LCP) fiber diaphragm is supported at two pivot points, with the voice
coil attached approximately midway between the two pivots. Since there is a
small unsupported diaphragm area, there is less opportunity to develop
performance-robbing resonance. The copper phase plug helps prevent phase
Mounting: The tweeters have multiple mounting configurations;
choose flush or surface mount. The Discreet Dual Clamp (DDC) flush mount system
provides concentric clamping pressure around the perimeter of the opening. The
surface mount housing can be positioned at two angles, approximately 15° or 30°
angle. Depending on the mount used, the installed dimensions are:
Tweeter Level: A switch on the crossover allows you to adjust
the output level of the tweeters; -4 dB, -2 dB, 0 dB, or +2 dB.
Bi-amp: The crossover has discrete inputs for the woofer and
tweeter, so each component can be powered by an individual amplifier channel.
Wiring: The crossover inputs and outputs are set screw clamps;
they will accept bare wire up to 12-gauge.
Power: In order to make any adjustments, the crossover requires
a 12 volt power supply.
Controls: The left and right channels are adjusted
- Tweeter Level: -4 dB, -2 dB, 0 dB, or +2 dB
- Tweeter Phase: 0° or 180°
- Woofer Crossover Frequency: 2.5 kHz or 3 kHz
- Woofer Crossover Slope: 6 dB/octave or 12
Bracket: A bracket is included so multiple T5652-S crossovers
can be stacked together.
- Width: 10-3/16"
- Height: 2-3/16"
- Depth: 7-7/16"