At Crutchfield, you'll get detailed, accurate information that's hard to find elsewhere.
That's because we have our own in-house Product Research team — they open the box,
verify contents, check the owner's manual, and record dimensions, features and specs.
We stay on top of new products and technologies to help people make informed choices.
Features
Compatibility: This enclosure is originally designed to work with a single 10" woofer
requiring a round cutout. The additional B-S08SQ baffle can replace the original
baffle, allowing you to mount an 8" square woofer. The enclosure has an internal volume of 1.00 cubic feet
(Type 2 for a 10" woofer and Type 3 for an 8" woofer), and can be configured as a sealed
or ported enclosure.
Materials:
The box is constructed of 5/8" MDF
(medium-density fiberboard), with a second MDF panel (3/4" thick) adhered to the
front panel to provide the mounting surface for the woofer. The
additional baffle is also made of 3/4" MDF. MDF
resists flexing and has anti-resonant qualities.
Design:
For strength, Q-Logic uses a full dado groove on the front, back, top, and bottom panels. The side panels are glued, then locked into these grooves. The edges of the front, back, top and bottom use mitered joints, so there's 50% more surface area for the special glue that bonds them. The side and front panel are framed with a hard plastic frame. The side panels of the box are recessed 0.5" from the outer edges of the frame, while the front baffle is recessed a minimum of 7/8". The trapezoidal shape of the enclosure better utilizes trunk space by allowing you to put the enclosure against the angled back of the back seat. The enclosure is covered with durable gray carpet.
QXs-Ring:
The QXs-Ring is a multi-diameter woofer mounting adapter which also seals the
woofer into the enclosure. The QXs-Ring has a series of rings around the outside
to help center the woofer, and hash marks to help align the woofer's mounting
holes. If the mounting diameter of the woofer is 9-1/8" or less, the
woofer can be installed without trimming the ring. For woofers with a larger mounting
diameter, a portion of the QXs-Ring can be trimmed off, allowing for an extra
1/4" in woofer mounting diameter. Note: The QXs-Ring can only be
used with the round cutout.
Interchangeable
Baffle: The original front baffle can be removed and replaced with the
B-S08SQ baffle
for 8" woofers with square cutouts. Eight Allen-head screws can be removed,
enabling you to remove the front baffle. A 4mm Allen wrench is required to
loosen/tighten the screws.
Spring Posts:
The spring posts, located on the left side of the enclosure, will accept bare wire,
pin connectors, banana plugs, and dual banana plugs. The enclosure is equipped
with a 30" speaker wire for connecting the woofer to the inside terminals.
Brackets: Brackets (not included) are recommended for more
secure mounting.
