Power Ratings: The Sound Ordnance M-2100 is a two-channel
Class AB amplifier with an RMS power rating of 75 watts per channel into 4
ohms, and 100 watts per channel into 2 ohms. The amp can also be bridged into a
4-ohm load for a power rating of 200 watts. Power ratings are measured with an
input power of 14.4 volts.
Crossovers: The M-2100 is equipped with both high-pass and
low-pass crossovers. You can set the low-pass cutoff frequency between 50Hz and
250Hz, and the high-pass cutoff frequency between 80Hz and 2kHz. A 3-way switch
lets you select low-pass, high-pass, or full range operation. The crossovers have
a 12dB per octave slope.
Super Bass: The amplifier has a bass boost switch, labeled
Super Bass, to give small subwoofers more volume in the low frequencies. You can
select the amount of boost with the 3-way switch: 0dB, 6dB, or 12dB.
LED Indicators: The M-2100 features two LED indicators: a green
LED that illuminates when the amp is powered on, and a red LED that illuminates when
the amplifier is in protect mode due to overheating or a short circuit in the speaker
Removable End Caps: The end caps on the M-2100 are removable
with a 3mm Allen wrench (not supplied) to make it easier to attach the power and
Power Connections: The power and ground connections are set
screw terminals that will accommodate up to 8-gauge wire. (An 8-gauge amplifier
wiring kit is recommended.) The remote turn-on terminal is a set screw terminal
that will also accept up to 8-gauge wire. A Phillips-head screwdriver (not
supplied) is required to tighten/loosen the terminals.
Speaker Connections: The speaker connections are set screw
terminals that will accommodate up to 8-gauge wire. A Phillips-head screwdriver
(not supplied) is required to tighten/loosen the terminals.
RCA Inputs and Outputs: The amplifier features a pair of stereo
RCA inputs for connecting your head unit. There is also a pair of stereo RCA outputs
for feeding the preamp signal to another amplifier, if needed.
Speaker Level Input: In addition to the RCA preamp outputs,
the amplifier also has speaker level inputs for connecting a head unit that does
not have preamp outputs. The supplied speaker level input harness has 4 bare
wires on one end and a 4-pin Molex plug on the other end.
Fuses: The M-2100 features one 30-amp ATC blade fuses.
Our Product Research Team
At Crutchfield, you'll get detailed, accurate information that's hard to find elsewhere.
That's because we have our own in-house Product Research team — they open the box,
verify contents, check the owner's manual, and record dimensions, features and specs.
We stay on top of new products and technologies to help people make informed choices.