Overview: The Sound
Ordnance USO Mixer (USO-MIX3) is intended for use in home and semi-professional
audio systems, mixing and controlling low-level audio signal from a variety of
different sources. Its a great addition to the Sound Ordnance PA System (sold
Peak/Level Output Display:
The front-panel Peak/Level Output Display indicates the device's output level.
If the white display LED lights up, the output level is too high.
Main Level Control: The
front-panel main level control sets the overall output level of the mixer.
Input Level Controls: The
front-panel input level controls (Phone/Line1/Line2/Line3/Mic) set the level of
the signal source connected to the corresponding input.
The front-panel tone controls let you adjust the tonal output of the mixed audio
signal with separate controls for the bass, midrange, and treble.
RCA Inputs: The Sound
Ordnance USO Mixer has 3 stereo line-level inputs for use with devices, such as
your CD player, MP3 player, or Tape deck.
Note: This audio mixer
is only intended for use with line-level audio signal inputs.
Phono Input: The mixer
features a rear-panel Phono input which lets you connect your turntable. Do not
connect your turntable to the other RCA jack on this mixer. A Phono ground
connection is available if your turntable has a ground cable.
Mic Input: A dynamic
microphone with a 1/4" jack can be connected to the mixer's front-panel Mic
input. There is a front-panel switch which turns the Mic input On or Off.
Note: When the Mic
input is turned on, the mixer's Line 3 RCA input is disabled.
RCA/XLR Outputs: The Sound
Ordnance USO Mixer is equipped with an unbalanced stereo RCA output and a
balanced stereo XLR stereo output. Either the RCA or XLR audio output will be
connected to your amplifier. The RCA/XLR outputs are located on the rear-panel
of the mixer.
Note: Do not connect
both RCA/XLR outputs to your amplifier.
Power Requirements: The
audio mixer can operate on either 110-120 volt or 220-240 volt alternating
current. The Input voltage is selectable. A 6.5' detachable AC power cord is
Indoor Use Only: The mixer
is designed for indoor use and should not be exposed to damp or wet
- Line: 7.4 kOhm
- Phono: .50 kOhm
- Mic: > 50 kOhm
- Line: 1.93 V
- Phono: 24.5 mV
- Mic: 17.5 mV
- RCA: 8.6 V with 10 kOhm
- XLR: 2.5 V with 600 Ohm
Frequency Response: 10-25,000 Hz
S/N Ratio: 90 dB
THD: 0.001 %
Channel Separation: 81 dB
Operation Voltage: 110-120 V, 50-60 Hz or 220-240 V, 50-60 Hz
Power Consumption: 5 watts
Fuse: T 100 mA/250 V (5 x 20mm); 110-120 V system
Our Product Research Team
At Crutchfield, you'll get detailed, accurate information that's hard to find elsewhere.
That's because we have our own in-house Product Research team — they open the box,
verify contents, check the owner's manual, and record dimensions, features and specs.
We stay on top of new products and technologies to help people make informed choices.