Panel Removal
|
The instructions below address, in general, what panels may need to be removed and how they typically come off. Often, panels can be pried up at edges. Screws and retaining clips might also be present that will require removal (Figure 1). To prevent damage, always use care when removing panels. |
|
Door Scuff Plate removalThe plates are usually removed by prying up the edges to release clips. Some vehicles will have screws present which will need to be removed (Figure 2). |
|
Seat Belt removalA seat belt may be located on the panel that needs to be removed. Most seat belt anchor covers pry off. The seat belt anchor is secured with a large nut or bolt (Figure 3). |
|
Pillar Trimpanel removalRemove seat belt if present. Remove screw covers, screws and plastic retaining clips, if present. Pry up edges of panel to remove (Figures 4 & 5). |
|
|
Kickpanel removalLook for screws and pry-out retaining clips to remove. Pry out edges of panel to release and remove (Figure 6). |
|
Routing wire behind the dash
Route wire behind the dash and secure with plastic wire ties. Be sure that wire does not interfere with any moving parts to ensure safe operation of vehicle.
Routing wire for components and power connections
Determine desired locations for each component. Use the most direct route for wires. Remove panels necessary to route and conceal wires. Test system before reinstalling panels.
Shop
