Oarhe O's 2003 Infiniti G35

Click the image to enlarge

Items installed:

• JVC KW-AVX720 DVD receiver
• Kenwood KAC-8405 4-channel amp (60w x 4)
• JBL GTO14001 monoblock amp
• Nitro BMWX2.2 2-Farad capacitor
• Alpine SWX-1043D 10" subwoofer
• 4-gauge and 10-gauge power wiring
• Axxess ASWC adapter for the steering wheel audio controls

Installation Description

First, I removed the trim pieces under steering wheel and under passenger dashboard. Then removed clock trim and the trim below shift knob, after removing shift knob. If it's a 5-speed AT, put the car in neutral, remove lower portion of shift knob and pull retaining pin out. If it’s a 6-speed MT, unscrew shift knob from shift boot.

After I got the trim pieces out of my way, I installed my double-din head unit and the A/C controller board in my new trim piece. Then I had to remove my navigation unit from my old center console trim piece and install it on my new trim piece. Once it was installed, I set every everything in place and connected all available harnesses.

The two that remained unplugged were my steering wheel volume control and my navi voice and mute lines. To fix the mute line I had to wire the gps to the TIP31 transistor and then the transistor to the mute line, wire the gps audio out +/- lines to a line out adapter, then to the amp through the high-end input.

Kenwood and JBL amplifiers mounted on the back seat

Then I ran RCA cables from my head unit to my JBL GTO 14001 and my Kenwood KAC-8405 amps. I ran a 4AWG power line from my battery to a distribution block in my trunk. the 4AWG line has both a 150A circut breaker and a 160A fuse within a foot of the battery. my JBL has a 4AWG line coming from the distribution block to it and my Kenwood has a 60A fused 10AWG line coming from the distribution block to it.

Nitro 2-Farad capacitor

I am using 10AWG speaker wire from my JBL to my Alpine 1043d and 12AWG speaker wire from my Kenwood to my BOSE component speakers and 10AWG from my Kenwood to my rear BOSE 6X9's. To finish this process, I replaced my trim pieces and replaced my shift knob.

Q&A Section

Why did you decide to upgrade your A/V system?

The G35 has a cheap circut board that is shared between the HVAC and the stereo, mine went out and I lost control of my stereo and heat/AC. My car was constantly blasting 90 degress and I had no audio.

What's the first thing you show people about your installation?

My head unit and my subwoofer.

Alpine Type-X 10" subwoofer

Why did you choose these products?

I chose these products for compatibility, quality and to achieve the sound I wanted.

What was the most difficult part of the installation?

Removing the clock trim.

What plans, if any, do you have for future upgrades?

I plan to replace my component speakers and 6x9's.

Oarhe behind the wheel

Vehicles in the Customer Car Showroom are submitted by customers and fans, and edited by Crutchfield writing staff. You can find more of these articles on the Showroom main page.