Our Product Research Team
At Crutchfield, you'll get detailed, accurate information that's hard to find elsewhere.
That's because we have our own in-house Product Research team — they open the box,
verify contents, check the owner's manual, and record dimensions, features and specs.
We stay on top of new products and technologies to help people make informed choices.
Stereo Amplifier: The JL Audio J2 360.2 is a class A/B stereo
amplifier rated at 110 watts RMS x 2 into a 4Ω load, 135 watts RMS x 2 into
a 3Ω load, and 180 watts RMS x 2 into a 2Ω load. When bridged the output
is 360 watts RMS x 1 into a 4Ω load, 270 watts RMS x 1 into a 6Ω load,
and 220 watts RMS x 1 into an 8Ω load.
Status LEDs: There are two LEDs on the left side of the
- Power: green LED indicates the
amplifier is turned on and operating normally
- Protect: red LED indicates the
amplifier has exceeded its safe operating temperature,
detected a short in a speaker output, or the speaker
impedance is too low
Active Crossover: The crossover can be set to high-pass, low-pass,
or off (full range). The crossover point is continuously variable from 50 Hz to 500 Hz
and the crossover slope is 12 dB/octave.
Bass Boost: The bass boost circuit is adjustable from 0 to +9
dB. The boost frequency is fixed at 45 Hz.
Power and Ground: The Power and Ground connections accept 4
gauge wire, which JL Audio recommends as the minimum size. The set-screw terminals
are tightened/loosened using the included 3mm Allen wrench.
Remote Turn-On: The remote terminal will accept 10 to 18 gauge
wire. The set-screw terminal is tightened/loosened using the included 2mm Allen
Speaker Outputs: The speakers' set-screw terminals will accept
8 to 16 gauge speaker wire; they are tightened/loosened using the included 2.5mm Allen
Preamp Inputs: The amplifier features one set of RCA line level
inputs. The input sensitivity is adjustable from 200mV to 4V RMS.
Speaker Inputs: When connecting the amp to a head unit
without line level outputs, use the included speaker level input harness. In
this case the input sensitivity is adjustable from 2V to 10V RMS.
Preamp Outputs: There is a pair of preamp outputs so you can
send audio to another amplifier in your system. The preamp output is not affected
by the crossover or bass boost circuits.