Our Product Research Team
At Crutchfield, you'll get detailed, accurate information that's hard to find elsewhere.
That's because we have our own in-house Product Research team — they open the box,
verify contents, check the owner's manual, and record dimensions, features and specs.
We stay on top of new products and technologies to help people make informed choices.
Volvo Radio Replacement Interface:
The CRUX SWRVL-54 is a radio replacement interface for select 1999-2012 Volvo
vehicles. It facilitates the integration of an aftermarket radio to enable
retention of factory features when replacing a factory installed radio in select
Volvo cars. This interface is also pre-programmed for retention of
steering wheel controls.
Compatibility: The CRUX SWRVL-54 is
supported by the following 1999-2012 Volvo vehicles; with non-amplified or
amplified factory audio systems.
Note: Please consult Crutchfield's
Outfit My Car to see if your vehicle is compatible and what additional
installation accessories will be needed.
Steering Wheel Control Retention: The CRUX SWRVL-54 also
features a steering wheel control output for Alpine, Clarion, JVC, Kenwood,
Pioneer, and Sony aftermarket head units. The steering wheel control output
consists of a right-angle 3.5mm connector and a light blue/yellow wire (use the
connection that your aftermarket head unit is fitted with). The SWRVL-54
interface module will work with any of the listed aftermarket head units, by
setting its three dip-switches (see owner's manual for appropriate setting).
Note: The steering wheel control harness features two 4-pin
connectors (labeled - Pioneer/Sony and Alpine/Clarion/Kenwood/JVC). You will
only plug in one of these connectors to the interface module, based on the
type aftermarket head unit you are installing.
Navigation Outputs: The CRUX SWRVL-54
radio replacement interface module provides a VSS (vehicle speed sense)
and a Reverse Gear output to make installing an aftermarket Navigation radio
simpler and less time consuming.
Amp Turn-On: The CRUX SWRVL-54
provides an amplifier turn-on lead for your vehicle's factory amplifiers (if
Wiring Harness: The included wiring harness features two 12-pin
connectors which plugs into your vehicle's factory radio harness, plus a 12-pin
connector which plugs into the SWRVL-54 interface module. The wiring harness also provides the following
bare-wire leads which will need to be hardwired to your aftermarket head unit's
||+12 Volt Accessory
||+12 Volt Constant
||Amp Turn-On/Power Antenna
||Left Front Speaker +
||Left Front Speaker -
||Right Front Speaker +
||Right Front Speaker -
||Left Rear Speaker +
||Left Rear Speaker -
||Right Rear Speaker +
||Right Rear Speaker -
||VSS (vehicle speed sensor)