Our Product Research Team
At Crutchfield, you'll get detailed, accurate information that's hard to find elsewhere.
That's because we have our own in-house Product Research team — they open the box,
verify contents, check the owner's manual, and record dimensions, features and specs.
We stay on top of new products and technologies to help people make informed choices.
Features
Inputs and Outputs Notes
Features
Internal Crossovers: The
amplifier's internal front and rear crossovers are 12dB/octave filters,
independently selectable for high-pass, low-pass, or flat (full range)
operation. Each crossover is variable from 32 Hz to 320 Hz. The low-pass filter
for the subwoofer channels can be adjusted from 32 to 320 Hz, and also has a
slope of 12 dB per octave.
Bass Boost: For added low
frequency performance, the subwoofer channels have a 0 to +12 dB variable bass
boost centered at 50 Hz.
Protection Circuitry: To keep
the amplifier safely operating, the protection circuitry is triggered in the
following situations: DC voltage on amplifier output, overheating, over voltage,
under voltage, and when there is a short circuit in the system.
Optional Neon Tubes: Using the
supplied mounting clips, you can install optional Street Glow AN9 neon tubes in the amplifier.
The neon tubes are installed by removing the amplifier's top panel, which is
transparent plastic.
Optional Remote Level Control:
The amp has an RJ-11 jack for use with the optional JBL remote level control
(item #109JBLRLC). This will allow the subwoofer level to be adjusted from the
listening position.
Inputs and Outputs Notes
Power Connections: The power
and ground terminals are set-screw terminals and will accommodate up to 4-gauge
wire. The remote turn-on terminal will accept up to 8-gauge wire. A
Phillips-head (not supplied) is required to tighten/loosen the terminals.
Speaker Connections: The
set-screw speaker terminals will accommodate up to 8-gauge wire. A Phillips-head
(not supplied) is required to tighten/loosen the terminals.
High Level Input:The amp has two speaker-level inputs, one for the front channels and one for
the rear channels. Each input has a 4-pin jack for use with the supplied
harnesses.
