Our Product Research Team
At Crutchfield, you'll get detailed, accurate information that's hard to find elsewhere.
That's because we have our own in-house Product Research team — they open the box,
verify contents, check the owner's manual, and record dimensions, features and specs.
We stay on top of new products and technologies to help people make informed choices.
This Q-custom enclosure is designed to be installed in the passenger's side rear
quarter panel in the 2002 and up Chevrolet Trailblazer, GMC Envoy, and
Note: This enclosure is
made for the 5-passenger models only. It will not fit EXT, XL, or XUV
The enclosure and fascia panel are made of strong, lightweight, tan,
thermo-formed ABS plastic. The side panel
of the enclosure features a 5/8"-thick MDF baffle for mounting the 10"
All mounting hardware, including a 2-piece metal mounting bracket, is included.
Enclosure Type: According to
Q-Logic's Bass Performance Match specs, this Q-custom is a Type I enclosure,
suitable for drivers designed for small, sealed enclosures.
Grille: A matching tan
pressure-fit, flush-mount grille is supplied for a custom look.
Speaker Terminals: The
Q-custom has two spring-loaded binding posts, which can securely accept bare
wire, pin connectors, banana plugs and dual banana plugs.
Woofer Orientation: Once the
enclosure is mounted in the vehicle, the woofer fires sideways toward the center
of the vehicle.
This enclosure has the following specifications (for proper fit and response,
the subwoofer of your choice should conform to the following specs):
- Driver Size:
- Internal Volume:
- Maximum Frame Diameter:
- Cutout Diameter: 9.11"
Panel Removal: Before the
subwoofer enclosure can be installed, removal of the factory side panel is
required. This requires a Phillips-head screwdriver to remove the upper trim
panel, and a #50 Torx bit to remove the upper and lower seat belt bolts.
Bracket Installation: In order
to install the mounting bracket, you will need a 10mm socket or wrench. The
amplifier on Bose-equipped vehicles is mounted in the same location. The bracket
will install over the amplifier using the same bolts that secure the amplifier.
Lower Trim Panel: In order for
the mounting studs to pass through the lower trim panel, holes will need to be
drilled in the storage pocket area. A drill and 3/8" drill bit will be needed.
Woofer Installation: Because
the enclosure is secured to the mounting location from the inside of the
enclosure, it is necessary to fully install the enclosure in the vehicle before
mounting the woofer in the enclosure.