Our Product Research Team
At Crutchfield, you'll get detailed, accurate information that's hard to find elsewhere.
That's because we have our own in-house Product Research team — they open the box,
verify contents, check the owner's manual, and record dimensions, features and specs.
We stay on top of new products and technologies to help people make informed choices.
More
Specifications
Features
Inputs & Outputs
Note:
Requires a 60 amp fuse which is not supplied with the amplifier!
More
Specifications
Dynamic Power Rating -
measured at 14.4 volts:
-
Mono into a 4 ohm load:
960 watts x 1
-
Per channel into a 2
ohm load: 480 watts x 2
-
Per channel into a 4
ohm load: 240 watts x 2
Continuous Power Rating - measured at
13.8 Battery Volts:
- 4 ohm, 20-20k, less than .05% THD;
both channels driven: 200 watts x 2
- 2 ohm, 20-20k, less than .1% THD;
both channels driven: 400 watts x 2
- 4 ohm, 20-20k, less than .1% THD;
mono: 800 watts x 1
Minimum recommended impedance load is
2 ohms in stereo mode and 4 ohms in bridged (mono) loads
Features
Die Cast Heatsink: Dissipates
heat for up to 30% improvement in cooling over conventional heatsink design
MEHSA: Maximum Efficiency Heat
Sink Application allows greater power output and maximum reliability
Trans Ana circuitry for a simpler
signal path resulting in better performance
Topaz: Tracking Operation
Pre-Amplifier Zone: Eliminates ground loops thus eliminating 80% of noise
problems
DSM: Discrete Surface Mount uses
high speed robotics manufacturing process which uses 0% tolerance resistors and
large board traces for greater reliability and efficiency
MOSFET power supply and output
devices
NOMAD (Non-Multiplying Advanced
Decision): An intelligent protection circuit that uses an analog computer to
make real time decisions regarding temperature, voltage, current and impedance,
thus protecting the unit without limiting sound output unless needed
Crossover switch: Can select high
pass, full (off) or low pass; slope is 12dB (Butterworth)
Inputs/Outputs
- LED: RED power
- REM input: Gold plated
.25" spade terminal
- Gold plated set screw terminals
for power and ground, note that there are two each, the second ground and
power terminal are for use with an optional energy storage capacitor.
The set terminals (speaker/power/ground) will accept bare wire size from 8
to 18AWG
- Gold plated set screw terminals
for left and right speakers (mono = +L and -R)
- Punch Bass knob: Adjustable
bass equalization rotary knob, can increase bass boost from 0-18dB at 45Hz
- Variable crossover frequency:
Rotary knob, variable from 50-210Hz
- Left and right variable gain
controls
- Left and right gold plated RCA
preamp inputs
- High level (speaker level) input:
Molex jack for use with supplied harness
