Our Product Research Team
At Crutchfield, you'll get detailed, accurate information that's hard to find elsewhere.
That's because we have our own in-house Product Research team — they open the box,
verify contents, check the owner's manual, and record dimensions, features and specs.
We stay on top of new products and technologies to help people make informed choices.
Metal Matrix Diaphragm
Derived from the C.M.M.D. material used in Infinity's flagship Cascade series, M.M.D. features a stiff aluminum core, anodized on both sides for increased
strength and rigidity. M.M.D. transducers conduct sound faster than paper,
polypropylene, and Kevlar, pushing unwanted resonances beyond the operating
range of the transducer. M.M.D. drivers deliver crystal-clear, distortion-free
sound from dynamic digital sources, even at high listening levels. The PS410 is
equipped with a front-firing, 10" M.M.D. woofer.
Surround: For a smoother
response and improved durability, the woofer uses a rubber surround.
Amplifier: This subwoofer is powered by a 300-watt (RMS) amplifier, rated at 27Hz - 150Hz with no more than 0.1% THD. The maximum (peak) power
output is 500 watts.
Bass Ports: There
is one rear-firing bass port that allows deep bass with high acoustic
efficiency and low distortion.
The subwoofer has a
rotary control on the rear panel for adjusting the level of the bass.
Low-Pass Crossover: The
subwoofer features a continuously variable 50Hz-150Hz low-pass crossover that
determines the highest frequency at which the subwoofer reproduces sounds. The
crossover has a 24dB/octave slope.
Note: The crossover is bypassed when
the "LFE/Normal" switch is in the "LFE" position.
The subwoofer's phase
switch allows you to control the phase of the subwoofer's output relative to the
front speakers. If the bass sounds muddy or unclear, toggling the phase control
can sometimes strengthen the bass "attack."
Auto On/Off Circuit: The auto on/off circuit turns the power amp on when a signal is sensed and
turns the amplifier off and into standby mode approximately 10 minutes after a
signal is no longer received. An LED indicator on the rear panel glows green
when the amplifier is on and red when the amp is in standby.
Inputs: The subwoofer has gold-plated stereo RCA inputs with an "LFE/Normal"
switch. If you have a Dolby Digital/DTS receiver or processor with a
low-frequency-effects (LFE) output, you should switch the "LFE/Normal" switch to
the LFE position. If your receiver/processor does not contain a Dolby Digital or
DTS processor but has a subwoofer output, you should switch the "LFE/Normal"
switch to the Normal position. In either case, you may use either the Left or
Right input. A "Y" adapter is not necessary.