At Crutchfield, you'll get detailed, accurate information that's hard to find elsewhere.
That's because we have our own in-house Product Research team — they open the box,
verify contents, check the owner's manual, and record dimensions, features and specs.
We stay on top of new products and technologies to help people make informed choices.
Features
Controls
Connections
Features
CEA 2006 Compliant: The XPA2500's power ratings are
measured according to the strict standards dictated by the Consumer Electronics
Association (CEA). These standards allow you to accurately compare the rated
power output of all CEA 2006-compliant amplifiers, even if they come from
different brands. Manufacturers who adhere to the standards can display the CEA
2006 logo on their products and packaging.
2/1-Channel Amplifier: The Dual XPA2500 can be set up for stereo or
mono-bridged operation.
2-Ohm Stable: The Dual XPA2500 amplifier can handle down to 2-ohm
loads in stereo operation and 4-ohm loads in mono-bridged operation.
LED Indicator: The LED
indicator illuminates green during normal operation (Power), and red when the
amplifier detects a fault (Protect).
Protection Circuitry:
The amplifier features protection circuits that will turn the amp off in case of
the following events:
- Speaker output contacts ground
-
Speaker wire short-circuits
-
Speaker load less than 2-ohms (stereo), or less than 4-ohms (bridged)
Controls
Input Sensitivity Rotary Control:
The input level control (gain) is used to obtain the best possible matched
between your headunit's output level and the amplifier's input level. 200 mV-6V
Crossover Mode: The
amplifier's built-in variable crossover allows you to filter out frequencies
above or below a certain point. You can choose between a low-pass crossover,
high-pass-crossover, or full-range crossover.
Crossover Frequency: This
control allows precise adjustment of the low-pass or high-pass crossover
frequency. This can be adjusted between 50 and 500 Hz. The crossover slope is
rated at 12dB/octave.
Bass Boost Rotary Control: You can apply a bass boost of up to +12dB at
45Hz.
Connections
12-Volt Power: The
amplifier is equipped with a 12-volt power screw terminal
which will accept up to 4 gauge wire.
Ground: The amplifier is
equipped with a ground screw terminal which will accept
up to 4 gauge wire.
Remote Turn-On: The
amplifier is equipped with a remote turn-on screw terminal
which will accept up to 4 gauge wire
Speaker Outputs: The amplifier features 4 speaker output
screw terminals which will accept up to 8 gauge wire.
Line In: The amplifier features one pair of stereo
RCA input jacks to connect to your aftermarket headunit.
Speaker-level input: The amplifier features a multi-pin input for use with included speaker level input harness
to connect to your factory radio.
Fuse:
The amplifier is equipped with a single 25A ATO fuse. The amplifier also
comes with a spare fuse.
