Chat
Contact us
Close contact box
Connect ID #
029 622 387 4
Connect ID #
029 622 387 4
Don't wait on hold. We'll call you back when it's your turn to talk with the next available .
Please enter your name  
Please enter your phone number  
Please enter a message  

Calls may be recorded for training and quality control purposes.

We are located in Virginia USA.

Thank you. We will be calling you .
We're sorry. We have encountered a problem.

JL Audio XD700/5 5-channel car amplifier — 75 watts RMS x 4 at 4 ohms + 300 watts RMS x 1 at 2 ohms (New Stock)

Item # 136XD7005

Each JL Audio XD amp packs a wallop far beyond what you'd expect from something so small.

Find what Fits your vehicle

Remove

Checking fit...

Each JL Audio XD amp packs a wallop far beyond what you'd expect from something so small.

2 questions - 2 answers

Item # 136XD7005

About the JL Audio XD700/5

Buck Pomerantz
Each JL Audio XD amp packs a wallop far beyond what you'd expect from something so small. This super-compact amp plays your music with true fidelity and impressive impact, without straining your car's electrical system. A cast alloy heatsink and an advanced cooling system keep these amps at optimal temperature, eliminating thermal shut-downs so your music keeps going strong without interruption.

Each JL Audio XD amp packs a wallop far beyond what you'd expect from something so small. This super-compact amp plays your music with true fidelity and impressive impact, without straining your car's electrical system. A cast alloy heatsink and an advanced cooling system keep these amps at optimal temperature, eliminating thermal shut-downs so your music keeps going strong without interruption.

Power an entire system
The XD700/5 5-channel amp can power your vehicle's entire system, delivering 75 watts RMS to each of your front and rear speakers, while powering a sub with up to 300 watts. You can also switch to 3-channel mode, and power your front speakers with 200 watts each, while still driving the sub with 300 watts. High- and low-pass filters give you intimate control over the character of your sound.

"Differential-balanced" inputs keep the signals clear of outside noise, and allow you to connect this amp to just about any in-dash stereo, even a factory radio with no preamp outputs. An optional wired remote lets you tweak the level from your front seat.

READ LESS

Product highlights:

  • 5-channel car amplifer
  • 75 watts RMS x 4 + 180 watts RMS x 1 (at 4 ohms)
  • 100 watts RMS x 4 + 300 watts RMS x 1 (at 2 ohms)
  • 200 watts RMS x 2 bridged at 4 ohms + 300 watts RMS x 1 at 2 ohms
  • variable low- and high-pass filters (50-500 Hz, 12 dB/octave, low-pass only on sub channel)
  • optional wired remote for level control
  • Class D amplifier design with NextD™ switching amp technology
  • differential-balanced inputs eliminate noise coming from your vehicle's electrical system
  • Advanced Rollback Protection System prevents thermal shut-down
  • speaker- and preamp-level inputs (speaker-level input requires an optional adapter)
  • 4-gauge power and ground leads and a 60-amp fuse recommended — wiring and hardware not included with amplifier
  • no onboard fuses — when installing multiple amps in a system, an additional 60-amp in-line fuse between the distribution block and the amplifier is recommended
  • 10-1/4"W x 2"H x 7-3/8"D
  • warranty: 2 years
  • MFR # 98264

What's in the box:

  • 5-Channel Class-D amplifier
  • Hex-key
  • JL Audio emblem
  • Owner's Manual

Customer reviews for JL Audio XD700/5

Loading reviews...

Average review:

5.0 out of 5 stars
14 reviews

Thanks for submitting your review

Filter by rating

Customer photos

Customer provided image, click to load a larger version.
Customer provided image, click to load a larger version.

Sort reviews

Sort by:
Items per page:
View page:

Verified customer (What's this?)
Verified employee review (What's this?)

Reviewed on Samsung.com

This review was collected as part of a promotion

Pros:

Cons:

Crutchfield response
Customer provided image, click to load a larger version.
<< >>

More details on the JL Audio XD700/5

Mark G.

Product Research

Features
Controls
Connections

Features

5-Channel Full-Range Amplifier: The JL Audio XD700/5 is a five-channel, class-D amplifier utilizing NexD ultra-high speed switching technology to deliver outstanding fidelity and efficiency. The XD700/5 can be operated with a wide variety of source units and system configuration.

Amplifier Rating: The JL Audio XD700/5 Class D amplifier is rated at 75 Watts RMS x 4-channels (front & rear) + 180 Watts x 1-channel (subwoofer) in 4-ohm at 20 to 20,000Hz with a signal-to-noise-ratio of 104 dB and a total harmonic distortion of 1% while receiving 14.4 Volts.

NexD Class D Technology: NexD is a state-of-the-art switching amplifier design that combines exceptional audio quality with excellent efficiency and less complexity. This results in an affordable compact amplification with exceptional audio quality and unsurpassed total efficiency.

Advanced Rollback Protection: The XD-Series amplifiers employ advanced thermal and low-impedance protection to virtually eliminate annoying amplifier shut-down events. Should any XD-Series amplifier ever overheat, its intelligent, unregulated power supply reacts by limiting available peak voltage until the amplifier returns to a safe temperature range. Likewise, if an impedance lower than optimal for the amplifier is present at the outputs, the XD amplifier will roll back peak voltage to protect itself without shutting down.

Differential-Balanced Inputs: The JL Audio amplifier features differential-balanced input architecture to effectively control noise and ensure compatibility with a wide variety of source units, including many OEM systems. Without resorting to line output converters, you can directly connect most OEM source units to the JL Audio amplifier without creating any noise or compatibility issues. Unlike conventional single-ended inputs, the differential-balanced design does not connect one side of the audio signal to chassis ground. This eliminates any voltage sensitivity between one input terminal and ground and greatly reduces the incidence of alternator whine in a typical car audio installation.

Note: You will need three speaker wire to RCA adaptors (136XDCLR2S, sold separately) to connect this amplifier to your headunit via speaker-level.

Protection Circuitry With Status Indicator Lights: There is a single multi-color LED on the top panel of the amplifier to indicate the amplifier's operating status.

  • Flashing Green: When the LED is flashing green, the amplifier is powering up and audio output is muted.
  • Constant Green: This LED lights green to indicate that the amplifier is turned on and operating normally.
  • Constant Red: This Red LED lights to indicate that the amplifier has exceeded its safe operating temperature, putting the amplifier into a self-protection mode, which reduces the power output of the amplifier. The red light will shut off and the amplifier will return to normal, full-power operating mode if the heat sink temperature drops back to a safe level.
  • Constant Amber (Yellow): The Amber (Yellow) LED light indicates that an over-current condition has occurred and is accompanied by a muting of the amplifier's output. Over-current condition can be caused by a speaker impedance lower than the optimum load impedance range for the amplifier or a short-circuit in the speaker wiring.
  • LED Off: The only condition that will shut down an undamaged XD700/5 completely is if battery voltage or remote turn-on voltage drops below 10-volts. The amplifier will turn back on when voltage climbs back above 11-volts.

Cooling System: The outer shell of the JL Audio amplifier is designed to remove heat from the amplifier circuitry. For optimum cooling performance, this outer shell should be exposed to as large a volume of air as possible.  Enclosing the amplifier in a small, poorly ventilated chamber can lead to excessive heat build-up and degraded performance.

Controls

Control Panel Cover: The XD700/5 features a Control Panel Security Cover which protects and hides the amplifier's controls. When installed, the cover ensures that the amplifier's settings are not accidentally changed while creating a clean aesthetic look for the amplifier and your installation. The control panel security cover is pre-installed at the factory and must be temporarily removed for access the amplifier's controls. The security cover is secured by two 2.5mm hex-head screws.

Simplified Gain Setting: The XD Series amplifier makes setting the gain level of the amp via the input sensitivity control very simple. All you need is Digital AC Voltmeter (142TK12V, sold separately) and a Test CD Disc (503CD104, sold separately) with a sine-wave test-tone recorded at 0 dB reference level in the frequency range to be amplified for that set of channels (50 Hz for subwoofer channels, 1 kHz for a midrange application).

Note: The XD700/5 is equipped with a independent gain controls for the 1/2, 3/4, & 5 channels.

Flexible Input Section And Active Crossover Network: The JL Audio XD amplifier provides a flexible input section and a comprehensive crossover network to fine tune your system effectively and accurately. The variable filter design employed in the JL Audio XD amplifier crossover sections allow you to seamlessly switch slopes, easily change filter frequencies and address what frequencies the preamp inputs will pass. The XD700/5 offers the following independent crossover adjustments for the front, rear, and subwoofer channels along the unit's top panel, behind a removal cover plate.

  • Input Mode: This switch allows operation of all 5 amplifier channels with only one pair of input signals (2ch); with independent front & rear input signal pairs (4ch); or with discrete front, rear, & subwoofer signal pairs (5ch).
  • Filter Mode: The amplifier allows you to select either a Full-Range or High-Pass crossover setting for channels 1/2 (front). For channels 3/4 (rear), you can choose between a Full-Range, High-Pass, or Band-Pass crossover setting. Either a Full-Range, a 12dB/oct. Low-Pass, or a 24dB/oct. Low-Pass crossover setting can bet chosen for the subwoofer channel (5).
  • Variable Frequency: For channels 1/2 (front), you can set the high-pass crossover frequency between 50-5,000 Hz. For channels 3/4 (rear), you can set the band-pass or high-pass crossover frequency between 50-500Hz. For channel 5 (subwoofer), you can set the low-pass filter frequency between 50-500Hz.
Connections

Power/Ground/Turn-On Terminals: The amplifier features set-screw terminals for the power, ground, and remote turn-on connections.

  • Power and Ground: The JL Audio amplifier's set-screw Power and Ground connections are designed to accept 8 to 4 AWG power wire. A 2.5mm hex-wrench is supplied for making connections.
  • Remote Turn-On: The JL Audio XD amplifier's set-screw turn-on lead will accept 18 to 8 AWG wire. The same 2.5mm hex-wrench is supplied for making connection.

Note: The Amplifier is not equipped with a fuse. An external 60-amp AFS, AGU, or MAXI fuse (not included) must be installed on the power wire. If a wiring kit is used which includes a fuse with a value other than 60-amps, the original should be replaced with a 60-amp fuse

Speaker Output Terminals: The XD700/5 amplifier's twelve set-screw speaker terminals will accept 16 to 8 AWG speaker wire. A 2.5mm hex-wrench is supplied for making connections.

Preamp Inputs: The amplifier features 3 pair of differential-balanced RCA jack inputs. The amplifier features a dedicated Input Sensitivity gain control for the front 1/2, 3/4, and 5 channels of the amplifier. These controls are designed to match the input sensitivity of the HD700/5 to the specific signal source that is feeding it. The amplifier's input level can be set independently for all channels between 100mV-4V.

Remote Level Control: The amplifier features a standard telephone connector for adding an optional wired remote level control. With the addition of the optional wired Remote Level Control (136HDRLC, sold separately), you can control the volume of all channels or just the subwoofer channel of the XD700/5 from the front of your vehicle. This is useful for subwoofer level control or even as a master volume control for your system. If desired, multiple XD amplifiers can be controlled from a single HD-RLC controller using a simple phone line splitter and multiple phone cables (all sold separately).

Note: All inputs and outputs are located on one side of the amplifier to make installation of the amplifier simple and neat.

Loading accessories...

Customer Q&A

2 questions already asked

Q
Can this amp run 4 6x8 full range speakers, and 2 smaller 8" kicker 2 ohm subs?
chuck  Apr 28, 2014
1 answer
A
Thanks for your question. For information on selecting the best amp for your subs I would recommend reaching out to an Advisor by phone (1-800-324-9695) or online chat. They will be able to help determine the differences between the amp models and help you make the best choice for your system.
kristina  Apr 28, 2014 (Staff)
Q
Do you guys sell a bass adjustment knob for this amplifier?
charlie  Jan 05, 2014
1 answer
A
With the addition of the optional wired Remote Level Control (136HDRLC, sold separately), you can control the volume of all channels or just the subwoofer channel of the XD700/5 from the front of your vehicle. This is useful for subwoofer level control or even as a master volume control for your system. http://www.crutchfield.com/p_136HDRLC/JL-Audio-HD-RLC.html?tp=3091
jeff  Jan 06, 2014 (Staff)

Loading articles...

Looking for more?

Check out the next model in this lineup.


Adding...
JL Audio HD Series HD900/5

JL Audio HD Series HD900/5

5-channel car amplifier — 100 watts RMS x 4 at 4 ohms + 500 watts RMS x 1
$1,499.99
Add to cart
Something went wrong. Please for help purchasing this item.

Want more power?

The JL Audio HD Series HD900/5 offers these features:
  • 100 watts RMS x 4 plus 500 watts RMS
  • stable at 1.5 ohm
  • stackable
Compare the sound