Features

Plus One Woofer Cones: The Plus One speaker cones offer more surface area than other speakers that fit in the same size opening. This is accomplished by using a new basket design and hi-roll surround. The result is greater bass output and an increase in efficiency.

High-Output Design: The high output 2.5Ω voice coil design compensates for the high in-line resistance of small gauge factory wiring and extracts every watt from factory receivers, increasing overall system output and efficiency (relative to 4Ω speakers). The speakers also benefit from increased power when you upgrade the wire and add aftermarket amplifiers, designed to power a 2.5Ω load.

Edge Driven Dome Tweeters: Each speaker has an Edge-driven soft dome tweeter. Edge-driven tweeters have better dispersion characteristics and allow for a lower crossover frequency than typical tweeters of the same size, which improves imaging, vocals and musical clarity. The tweeter also has an output level switch; choose +0 dB (flat) or +3 dB. The tweeter is angled and can be rotated about 270° after installation. This allows you to direct the tweeters toward the listeners, useful for speakers mounted low in a door.

Mounting Applications: These speakers are marketed as 6-1/2"; they will fit in standard 6-1/2" speaker openings (approximately 5" diameter), but do not use the standard 6-1/2" speaker bolt pattern. In order to install them in standard 6-1/2" speaker openings you must drill new screw holes. If new holes are drilled in the mounting surface of the car, no bracket is needed. If drilling in the car is not an option, the included brackets can be used, which have standard 6-1/2" mounting holes and the Ford non-symmetric four hole pattern. When using the brackets the depth becomes 1.85" and the mounting height becomes 1.121". Please enter your vehicle information to confirm fit.

Terminals: The input terminals are set screws that will accept up to 12 gauge bare wire.