About the Blaupunkt PCA2120
The slim, classic exterior design of a Blaupunkt ProComponent amplifier is only the tip of the iceberg. Beneath the striking silver-accented finish you'll find a rugged amp that'll deliver solid performance over the long haul.
The PCA2120 2-channel amplifier brings plenty of power to the party. Use two channels to rev up even the most power-hungry component systems or full-range speakers or switch to single-channel mode to supply a subwoofer with plenty of juice. However you choose to use it, variable frequency filters adjust the amp's output to fit your needs. A variable bass boost circuit adds low-end punch when you need it.
- 120 watts RMS x 2 at 4 ohms (180 watts RMS x 2 at 2 ohms)
- 300 watts RMS x 1 in bridged mode (4-ohm stable in bridged mode)
- variable high-pass/low-pass crossover (50-250 Hz, 12 dB/octave)
- variable bass boost (0-12 dB)
- preamp-level inputs and outputs
- CEA-2006 compliant
- Tri-way capable (Tri-Way crossover required)
- fuse rating: 25A x 2
- 4-gauge power and ground leads recommended wiring and hardware not included with amplifier
- 12"W x 2-1/8"H x 10"D
- warranty: 1 year
- Our 60-day money-back guarantee
- MFR # PCA2120
What's in the box:
- Two-channel amplifier with two 25A ATC fuses inserted into the chassis
- 4 Self-tapping screws
- Owner's manual
Blaupunkt PCA2120 reviews
Thanks for submitting your review
More details on the Blaupunkt PCA2120
Features & specs
|RMS Power Output (Watts x Channels)||
120 x 2 |
|Peak Power Output (Watts x Channels)||N/A|
|Power at 2 Ohms (Watts x Channels)||180 x 2|
|Bridged Power (Watts x Channels)||300 x 1|
|Minimum Impedance Bridged||4|
|Minimum Impedance Unbridged||2|
|Best Frequency Response||20-30k Hz|
|THD at Rated RMS Power||0.1%|
|Signal to Noise Ratio||101 dB|
|Low-Pass Crossover Frequency||50-250 Hz|
|Low-Pass Slope (dB/octave)||12 dB|
|High-Pass Crossover Frequency||50-250 Hz|
|High-Pass Slope (dB/octave)||12 dB|
|Bass Boost||0-12 dB|
|Bass Boost Frequency||N/A|
|Fuse Rating||25 x 2|
|Speaker Level Inputs||---|
|Preamp Outputs||1 pair|
|Parts Warranty||1 Year|
|Labor Warranty||1 Year|
Protection LED: The amplifier has an LED on the right panel that glows red when the protection circuit is activated.
Built-in Crossover: The internal crossover is continuously variable from 50-250 Hz and has a slope of 12 dB/octave. The crossover can be set for low-pass, high-pass, or full-range operation.
Bass Boost: For added low frequency performance, the amp has a 0 to +12 dB variable bass boost.
Preamp Level Outputs: The set of preamp level outputs can be used to send a full-range signal to an additional amplifier.
Power/Ground Terminals: The power and ground screw terminals are 0.54" wide to accommodate 4-gauge wire.