About the Pro.Fit Wire Worm
Pro.Fit's "Wire Worm" tool helps you route your wires during installation. Just tape your wire to it, then fish it under your dash or carpeting, or push it through holes or behind panels in order to pull the wire through to the desired destination. The 48-inch, rigid nylon Wire Worm stays straight, yet it's flexible enough to handle corners. And it won't scratch your vehicle's interior or existing wiring.
What's in the box:
- 1 Wire fish tool
Pro.Fit Wire Worm reviews
Thanks for submitting your review
This review was collected as part of a promotion
More details on the Pro.Fit Wire Worm
Overview: The ProFit DM-45-33 Wire Worm is a specialized tool to assist you in routing wires under the dash cavity, under carpeting, above headliners or through your vehicle's firewall. It is 0.385" wide x 47.875" long and made of nylon that is rigid enough to follow a line, yet flexible enough to turn corners without collapsing. It will not scratch or cut your vehicle's interior or wiring and will not harm any components that it comes in contact with. You can either thread your wires through the 0.125" x 0.25" hole at either end of Wire Worm or use electrical tape to secure your wires to the end of the Wire Worm.
1 question already asked
Well it saved my hand, knuckles and installing time. No pulling seats too run rca, speaker and remote wires. Well worth the money!! One suggestion is too remove it from package and lay it flat on hard surface in the sun if possible. place a brick on each end overnight. Nice and straight.
Michael from Stockton, CA