About the Q-Forms Kick Panel Enclosures
Many award-winning sound-off competitors put their mid-woofers and tweeters in custom-built kick panel enclosures because that's one of the best ways to get a concert-quality stereo image. But why pay hundreds of dollars to an installer? Mount your 5-1/4" components in Q-Logic's Q-Forms, which deliver competition-quality imaging without the expensive custom installation work.
With Q-Forms, each speaker is located and angled to maximize sound quality. The theory is that the distance between your ears and each of the speakers should be equal. With your speakers in the kick panels, it's like sitting in that "sweet spot" at a concert or right between your home speakers.
All the available colors for the Q-Forms that fit your vehicle are listed here. Pick the color that matches your interior. If there is no match for your vehicle, that means Q-Forms are not available for it.
Installation note for 1983-1994 Ford Ranger
1983-1990 Ford Bronco II:
To install, move parking brake about 3" (spacer included). In pre-1992 models, relocate computer from passenger side kick panel (disconnect battery before moving it).
Thanks for submitting your review
More details on the Q-Forms Kick Panel Enclosures
Compatibility: Ford: Bronco II 83-88, Ranger Pickup 83-88.
Features: Color matched to interior of your car Molded in one piece for factory appearance Speakers positioned and angled for optimum stereo staging and imaging Equalized path lengths reduce right/left volume bias Original kickpanel can be replaced if desired.
Installation Notes: Mounting speakers requires cutting out a mounting hole in plastic. Tweeter can be flush or surface mounted, but if surface mounting make sure to allow for clearance from obstructions such as parking brake. Giving exact mounting depths is not possible, since it will depend to some extent on the space available behind the factory kickpanel; however, the minimum flush mount depth for the tweeter is .75" and 2.5" for the woofer/mid bass component. This unit allows you to mount a tweeter with a maximum diameter of 2-1/2 inches and a midrange/midbass unit from 3 1/2 to 5 1/4 inch. The maximum cut-out you can make for the midrange/bass unit is 5.9", so a few 6.5" units may fit, but make sure to check the specs/features for cut-out and mounting depth of any components you sell.
Installation tools required: hole saw (can also use air saw or keyhole saw), screwdriver.
Estimated Installation time: 2 hours per manufacturer.