Installed in a Freightliner M2 106

Amplifier works great with my Rockford Fosgate T16 speakers

Have questions for
?

JBL Stage A6002

Wiring was very easy Liked the small size to fit inside my fairing. Love the sound output.

Have questions for
?

Perfect little 2-channel amplifier

I bought this 2 channel amp to run a pair of 3 ½ JBL 2-way speakers on my dash. The 4-way amp was pushing too much wattage and these 3 ½'s were blasting my ears! This tiny amp was just the right size to mount inside the driver's side of my dash and do the trick. I used a volt/ohm meter and a formula to get the amp to set the gain at only 25 watts output, required for the 3 ½ JBL speakers RMS wattage.

Have questions for
?

Low distortion, good power, in a small footprint.

Solid piece. If you like equipment of comparable quality to Crown, this is it. I heavily modified my truck and wanted it to be easier to work on. I didn't want bluetooth junk either. I will run the factory radio into the Speaker level inputs, then run an AUX cord to my phone. I still have some fabrication to do. The stock radio is fine. It just needs more power. Before installation, I tested it to see what input levels cause distortion. The pictures have the Amp in blue. Distortion at high Frequency happens at 520 mv. 630mV makes that tiny whisker of distortion at common lower frequencies below 15k The clipped signal is 680mv at a lower input level. The noisy signal is 14k, 1/3 volume. The distortion is inaudible, so it's fine. -- LS3 swap Baby!!!

Have questions for
?

JBL Stage A6002

The amp seemed to work perfectly, just not with the factory system in my challenger

Have questions for
?

JBL Stage A6002

A very small amp that will fit almost anywhere. I used it as a second amp to power my front pair of Infinity Reference 6030cs. It rounded out the system & gave me what I was looking for at a good price, and like always the included instructions for hooking up 2 amps were spot on.

Have questions for
?