About the Metra 70-5520 Receiver Wiring Harness
Metra 70-5520 Wiring Harness
Metra 70-5520 Wiring Harness
This vehicle-specific wiring harness makes connections between your new car stereo and your car's electrical system.
First, attach the color-coded wires on your Crutchfield-supplied harness to the wires from your new stereo. If you're not using a soldering iron, we recommend that you purchase some wire connectors to secure the connections. Check out our handy article on three ways to connect the wiring harness here.
Now, once this harness is connected to your new stereo, you'll be able to plug right into your car's factory radio connector. This harness saves installation time since you won't have to cut factory wires individually, and this also enables you to re-install the factory radio if needed. A detailed instruction sheet comes with the harness. Warranty: 60 days.
Please read this important note: This harness may not contain provisions for every wire needed to complete your installation, and it will not accommodate special navigation, video, or factory steering wheel control connections. You will need a special adapter if you want your factory steering wheel audio controls to work with your new stereo.
- 12V constant power
- 12V switched power
- chassis ground
- left front speaker +/-
- right front speaker +/-
- left rear speaker +/-
- right rear speaker +/-
It came with wiring instructions and it was clear on where the wires went and I was able to wire it up and solder it and it worked just fine
Jacob from Fair Oaks Ranch, TX
can a Metra ASWC-1 be wired to this harness? if not can additional Pins/wires be added to the harness? I do not want to cut the factory harness at all.
No they can not but the Axxess steering wheel mine has been replaced 3 times still does not work look for the Metra steering wheel controls or different brand.
Metra 70-5520 Receiver Wiring Harness reviews
Thanks for submitting your review
Thank you for submitting your review!
It may take up to a week for your review to appear.
Filter by rating
More details on the Metra 70-5520 Receiver Wiring Harness
Crutchfield Wiring Harness: Crutchfield wiring harnesses prevent you from having to cut your vehicle's factory radio plug when replacing your factory radio with an aftermarket head unit. Simply solder or crimp the Crutchfield wiring harness to your aftermarket head unit's harness (solder & crimps not included), plug the aftermarket head unit's plug into the rear chassis of the aftermarket head unit, and plug the Crutchfield wiring harness into your vehicle's factory radio plug.
Note: Installation tools, hardware, & accessories are not included & sold separately. Please see the Accessories tab for recommendations & availability.
Wiring Notes: If the Crutchfield wiring harness is not equipped with a ground wire, you will need to ground the aftermarket head unit's ground wire to the metal chassis of your vehicle. Some vehicle's may require you to bypass the vehicle's factory amplifier (in another location from factory radio) or hardwire certain connections. If your vehicle is equipped with factory steering wheel controls, an additional adapter is required & sold separately.
Wire Code Chart:
|Red||+12 Volt Accessory|
|Yellow||+12 Volt Constant|
|White||Left Front Speaker +|
|White/Black||Left Front Speaker -|
|Gray||Right Front Speaker +|
|Gray/Black||Right Front Speaker -|
|Green||Left Rear Speaker +|
|Green/Black||Left Rear Speaker -|
|Violet||Right Rear Speaker +|
|Violet/Black||Right Rear Speaker -|
Q Crutchfield asked: Why did you buy this?
7 questions already asked