About the Metra 71-035LC Speaker Wiring Harnesses
Metra 71-035LC harnesses
Metra 71-035LC harnesses
These harnesses allow you to plug your new speakers into the factory connectors present in your vehicle's speaker openings. They are priced per pair. Please enter your vehicle information or call an Advisor at 1-888-955-6000 to find out if these adapters are compatible with your vehicle. Warranty: 60 days.
Note: Some aftermarket speakers have terminals that are wider than this harness's slide-on connectors. You may need to widen the harness's female slide-on connectors, or use the slide terminals that may be included with the speakers. If you need to connect your new speaker's connectors to the Crutchfield harness, soldering is best, and crimping is also very popular — see "Accessories."
Adequate match maker for the 2009 Subaru Forester (front) and the Polk DB 652. The harness side was plug and play. The speaker side was tight, so I needed to loosen the clips a little. Be careful you don't push too hard and bend/break the tabs.
Tyrone from Allentown, PA
will these work on a 2018 Subaru wrx front and rear door speakers?
I got them on a 16 so I'd say yes.
Metra 71-035LC Speaker Wiring Harnesses reviews
Thanks for submitting your review
Thank you for submitting your review!
It may take up to a week for your review to appear.
Filter by rating
More details on the Metra 71-035LC Speaker Wiring Harnesses
Speaker Harness: These speaker harnesses prevent you from having to cut your vehicle's factory speaker plugs when replacing your factory speakers with aftermarket car speakers. The speaker harness features two female quick-slide connectors on one end to attach directly to your new aftermarket car speakers & a proprietary Molex connector on the other end that connects to your vehicle's factory speaker plug.
Quick-Slide Connectors: The speaker harness is equipped with a large (positive) & small (negative) female quick-slide terminal. These quick-slide terminals fit directly onto most aftermarket car stereo speaker terminals (slight crimping may be required). In rare cases that the quick-slide terminals do not fit your car speaker terminals, you will need to solder the speaker harness to your aftermarket speaker's terminals or replace the quick-slide connectors on the speaker harness with the correct size terminal.
Note: Installation tools, hardware, & accessories are not included & sold separately. Please see the Accessories tab for recommendations & availability.
Quick-Slide Terminal Measurements: The positive female quick-slide terminal measures 0.205" (inner width), while the negative female quick-slide terminal measures 0.115" (inner width).
Wire Code Chart: Two identical speaker harnesses are included.
Q Crutchfield asked: Why did you buy this?
6 questions already asked