Metra 95-7313 Dash Kit

As advertised

Have questions for
?

Perfect

Made the radio look like original equipment.

Have questions for
?

Metra 95-7313 Dash Kit

I was expecting something a little more sturdier but it got the job done. Had to trim a little of it to get it to fit.

Have questions for
?

Metra 95-7313 Dash Kit

Didnt fit my car right, not sure if its the fault of this product or Crutchfield.

Have questions for
?

Metra 95-7313 Dash Kit

Fit perfectly, made the install super smooth. Installed it with my son, so it was a positive teaching experience as well.

Have questions for
?

Metra 95-7313 Dash Kit

Worked well enough but had some minor fitment issues.

Have questions for
?

Hyundai/Kia Kit

Did not fit 04 tiburon. It was too wide to install in opening. Had to remove brackets from old radio and adapt to new radio. Very time consuming to accomplish.

Have questions for
?

Perfect

Very easy to use and install. Figured it out with no instructions. Would recommend.

Have questions for
?

Metra 95-7313 Dash Kit

Perfect fit

Have questions for
?

Metra 95-7313 Dash Kit

Faceplate looks cheap

Have questions for
?

Works OK

Fits as described, but the other edge is not ridged enough and can interfere with the display screen when tilting. The side flanges slide into the face frame as they should, but the screw cut outs on the front are too large, and difficult to fasten properly.

Have questions for
?

A must

A must have. Perfect fit, easy to install.can't ask for more!

Have questions for
?

Custom Look!

This part made my installation look like a professional did it! I have never done an install myself, and it looks great! Excellent instructions and support!

Have questions for
?

Missing a few mounting tabs

Easy to install with easy to follow instructions as always from Crutchfield. The only issue I have with this product is the factory radio mount had two lower screw tabs to support the radio from the bottom, with four more on the sides. This product only had the side mounts which worked fine but I was a little concerned that the bottom mounts would hold the double din unit up better had they been there. Time will tell. Other than that, installation was a breeze. I would recommend this product to a friend.

Have questions for
?

Fits perfectly.

Like most Metra kits, some assembly and general installation knowledge are required. Instructions are adequate and the finished install is seamless.

Have questions for
?

Dash Kit

Dash Kit was east to install. Stereo fit great in it and looks good. Looks OEM

Have questions for
?

Dash Kit for radio install on 2004 Hyundai Sonata GLS

Perfect Dash Kit to mount the new radio that replaced the factory radio in the '04 Sonata. It's plastic, but the side parts are quite sturdy. It did not come with screws - so we used the 4 screws that came with the radio. Lots of openings on the side so you can make sure it will align. Installed straight in without having to readjust. There's a 4-prong and 3-prong on the sides, so really only one way to put it together, although it did come with instructions and the sides are labeled (left/right). I would have preferred a few more screws to really secure the radio, but realistically: there's no where for the radio to go, so 4 screws will definitely suffice to keep it well in place. Recommend this product.

Have questions for
?

Metra 95-7313 Dash Kit

Intsalled ok except the pieces didn't line up exactly as designed. I ended up need to remove the stereo and part of the several times in an attempt to get the face plate to fit properly around the stereo. In the end the the trim ring did not fit into the hole in the dash property and is slightly askew.

Have questions for
?

Fit to finish.

It is a good kit but I had to so some filing to get it to fit properly on the dash not a big deal.

Have questions for
?

Fits 2005 Santa Fe better than 95-7309 kit

Fits in my 2005 Santa Fe better than the 95-7309 kit that was designed for it. Still had to modify it slightly by extending the current "cutout" on top by about an inch on each side. Was way less modification than the 7309 kit would have required. With the later model first gen Santa Fe's the buttons and indicators above the heat vents are different, when the dash is put back in place they put pressure on the dash kit and in turn bends the top of the face of the head unit above the dvd slot. I would like to add that this kit allows the head unit to sit where it should instead of extremely recessed like the 7309 kit. (i couldn't even grab my volume knob it was so deep before) Also, Crutchfield has the image of this kit upside down.

Have questions for
?

Does NOT fit a 2004 Santa Fe

This was sent as part of the installation kit I purchased along with the Jensen VX-3022 unit for my wife's 2004 Hyundai Santa Fe (has the 6-CD Monsoon unit). This 95-7313 IS EASILY 1/8"+ too wide for the opening in the dash of the Santa Fe. In fact a Santa Fe isn't even listed in the manual that comes with the 95-7313. I had to cut pieces off and glue part of it back together so it would fit and allow me to get the dash piece back on correctly.

Have questions for
?

Fit couldn't be better

Looked like a perfect factory install when we finished. Very happy as always - thank you Crutchfield

Have questions for
?

Perfect fit!

After reading many very negative reviews about Metra install kits for my 2006 Tiburon I was a little concerned when I had to order this one. After receiving and reviewing the installation instructions I began the install and I now wonder what all of the negativity was about! The kit installed my Pioneer double dim radio perfectly and, including tying all the wires together, the total installation time was about one hour.

Have questions for
?

Great!

Fit perfectly in my Hyundai Santa fe 2004. I'm so happy because now I can listen to music on my phone. It looks really smooth too no gaps or anything.

Have questions for
?

Easy peasy

Works like a charm. Don't manhandle it or you can break it!. In the 2003 Santa fe install upside down!! And lower in the cavity than the original double din radio. Careful with install screws the fascia is plastic and if you over torque screws, you'll be sorry.

Have questions for
?

Plastic adapter bracket

Only four stars because, let's face it, plastic is cheap, chinsey and easily broken.

Have questions for
?

Metra 95-7313 Dash Kit

Works as described

Have questions for
?

Needed accesory

This item was the perfect fit for my 04 Sonata. I installed a Kenwood DD receiver. Once the factory installed radio brace is removed installation was a snap.

Have questions for
?

Metra 95-7313 In-dash Receiver Kit

The sides worked great , I didn't use the front trim it wouldn't allow the motorized face of the DNN990HD to close right.

Have questions for
?

Metra 95-7313 Dash Kit

Installed into a 2005 Kia Optima LX with a Pioneer AVH-X4500BT. This is a DVD reciever, unfortunately the Metra kit will NOT work with DVD players that have a fold down screen to load the DVD(Metra tech rep replied to my e-mail confirming this). Just used side pieces. Good customer support from Metra but wish they had a note in the booklet that came with it indicating that the above receiver will not fit.

Have questions for
?

Metra 95-7313 Dash Kit

Decent product! Works as intended, facilitates installation of head unit. Although, the bracket should be more application specific in that it should replicate all anchor points of the OEM equipment so it can provide equal support.

Have questions for
?

Metra 95-7313 Dash Kit

Great product easy to install. Fit my dash perfectly.......................

Have questions for
?

Perfect for 2004 Sonata

The kit fits the dash opening perfectly and makes the JVC double DIN I installed look like factory. Simple to assemble.

Have questions for
?

Just what I needed!!!!

After I figured out how it was used installation went smoothly

Have questions for
?

Worked perfect

Worked perfect for my install. I was installing a new Pioneer FH-X500UI in my 2003 Hyundai Tiburon and had no issues with this kit. I followed the instructions and it fit perfect. Looks like it was a factory install because of this!

Have questions for
?

EASY INSTALL!!

WORKS AWESOME, EASY INSATLL

Have questions for
?

Works well

Does the job, fits well in the car. Feels sturdy enough. And doesn't look cruddy once the install is finished.

Have questions for
?

not so much

didn't work, didn't use, had to modify factory brackets to install

Have questions for
?

Perfect fit Hyundai Santafe!!

Eventhough this kit is not listed for a 2003 Hyundai Santa Fe, it is the perfect fit for it If you have the Monsoon stereo upgrade. (Perhaps others as well, not sure on that) The one recomended by Crutchfield does not work due to being too bulky, this kit will work and look like factory. I have a Sony XAV-64bt and it look awesome

Have questions for
?

Perfect Fit

This kit was a perfect fit for my car and head unit.

Have questions for
?

Good fit after some trimming

The bracket fit my double DIN head unit perfectly with a couple minor exceptions. The side tabs on this kit provide a number of precut openings for mounting screws. One opening on each side aligned perfectly with the existing screw locations on my head unit. Two more required minor enlarging of the tab opening to line up well. After making this mod I had two screws on each side securely holding the bracket to the head unit. I then tried sliding the bracket into the dash opening and discovered that more trimming was needed to allow the bracket to align properly in the dash opening. First I had to trim about an eight of an inch off of each side tab on the kit where they protruded above the top of the head unit. Until I did this the unit sat too low in the dash to line up with the dash mounting screw holes. Once that was done the radio itself fit fine but then I noticed that the mounting tabs sticking out in front to mount the radio to the dash were too long to allow the car trim panel to be reinstalled properly after the radio was installed. I shortened those tabs up with a dremel tool so the panel would seat properly on both sides of the radio and that still left plenty of mounting surface under the screw heads to secure the unit to the dash. This all sounds like more work than it really was. The plastic parts are pretty easy to trim. The end result is a securely mounted good looking install.

Have questions for
?

Fits, but need some work

It fits, but it is very very snug. I had a hard time get it to line up right. There are two holes in the dash for mounting at the top, this only uses one and its not the top hole i found out (the directions are very unclear here). Plus even after remounting to the lower hole i could not get the dash faceplate on. I had to loosen the screws and push it as high as i could while keeping it mounted in the lower holes. The dash plate still took some work getting on. If you don't do the push up, the bottom brackets in the dash plate will not meet the lower holes. I also had to trim a bit of the plastic off the outside edge of the kit and really push towards the radio on both sides on the dash plate to get that area to pop into place.

Have questions for
?

Metra 95-7313 Dash Kit

I didn't really need this, the trim w/the stereo fit in my existing opening

Have questions for
?

sloppy fit, cheap materials

This was the cheapest piece of plastic I've ever seen. It fit--- kind of, after you have to sand off the tabs so that it actually fits the car, but the plastic is warped and bends down to cover the cd slot. Really really cheap.

Have questions for
?

Required modification

I got this with the Clarion NX409. The trim piece the brackets fit into didn't fit around the face of the deck, but th fit was fine with just the deck face. The brackets themselves required some additional drilling to match up with the deck's screw holes. In the ones it lined up with naturally, it caused the deck to be too recessed in a 2001 Elantra. But, it worked after some slight modification, and making one plate for every deck out there can be tricky, so I'll give them some credit. In the end, it got the job done, just not quite out of the box.

Have questions for
?

Works....but....

For single-to-double din upgrade, this kit needs some tweaking to fit in the '07 Tib. I had to cut the brackets apart, using the lower 3-hole tab part (as pictured) to make the HU fit. Not a perfect fit, as the lower mounting holes in the dash console are recessed back. Still, works using just the upper mounting holes and drilling a couple of additional holes for support.

Have questions for
?