Metra 95-7805CH Dash Kit

This dash kit fit very well and gave my car a clean look. The color also matched the color of the dashboard so that was cool

Have questions for
?

Metra 95-7805CH Dash Kit

The kit fit up nicely and has pretty decent instructions as well. I did use a video to get a better representation of dash disassembly, but I could have managed by just using the supplied instructions.

Have questions for
?

Metra 95-7805CH Dash Kit

Perfect fit

Have questions for
?

Good and bad

The Dash Kit fit my 2009 Acura TSX just fine. Unfortunately the double DIN cutout for my Kenwood DMX907X was a mismatch. After spending way too much time trying to make it fit I pulled out my Dremel grinder and had to grind millimeters off all four sides to make it fit quite nicely. At least the ground edges were covered up by the Kenwood trim plate. I had called Crutchfield technical support. He understandably could not provide an answer though he made a valiant effort. I did not verify if the Kenwood head unit was not standard, nor if the Metra cutout was not standard.

Have questions for
?

Acura Boss Install Dash

Easiest piece of install after popping out old equipment

Have questions for
?

Metra 95-7805CH Dash Kit

I used this the install an alpine ILX-650 headunit in a 2012 TSX. The dash kit is a pretty close match to the rest of the dash. The color and texture are just slightly off from the oem panel. The panel feels a bit more flimsy and cheap compared the the factory panel but does what it is supposed to and will hold up to normal use.

Have questions for
?

Be ready to modify to your radio

It's decent quality and fits the dash mostly. There's a slight (1/4") protrusion at the bottom outer corners of either air vent. My main issue with this is that I bought it with the assumption that it would fit my DD radio. That was not the case. I had to bring a dremel to it to cut off about 1/4-1/3" on either side so that my radio would fit.

Have questions for
?

Metra 95-7805CH Dash Kit

Looks nice once installed. Feels flimsy. Had noticeable gap on the Kenwood headunit I used it with, but Kenwood-supplied trim ring would not fit into the opening of the Metra trim plate. Had to dremel it quite a bit to get the Kenwood trim ring to fit so there was not a noticeable gap. Happy with end result but took more effort to get there than it should have, given that this product is specific to my vehicle and the headunits are standard sizes.

Have questions for
?

Metra 95-7805CH Dash Kit

Excellent product, radio installation was a perfect fit!

Have questions for
?

Metra 95-7805CH Dash Kit

Kit works and surprisingly has no rattles. Unfortunately the fit and finish left a lot to be desired, works perfectly just wish it looked better.

Have questions for
?

Your only option

This dash kit is well made and it blended perfectly with the dash on my 2012 Acura TSX. However, it did NOT fit the Kenwood DNX893S receiver as it was supposed to. It required considerable modification with a Dremel tool to fit the receiver, which has an unusual tilt screen design. The photo shows how the radio opening had to be enlarged to accommodate the radio's trim ring.

Have questions for
?

Metra 95-7805CH Dash Kit

This trim panel does not fit snugly in the dash. The right side sticks out about 1/8 of an inch. The top line does not follow the factory dash opening very well.

Have questions for
?

Metra 95-7805CH Dash Kit

Easy to install and matches oem finish

Have questions for
?