About the Pioneer TS-W261D4
Built tough for solid bass
Built tough for solid bass
Pioneer's TS-W261D4 10" subwoofer is built to take it as well as dishing it out. This Pioneer Champion Series sub features a ribbed cone that's injection-molded for exceptional precision and strength. A double-layered elastic polymer surround supports the woofer during cone excursion so you'll get accurate, hard-hitting bass notes even when things get loud. And the dual 4-ohm voice coils allow you to wire the sub for 2- or 8-ohm impedance, so you get the flexibility you need to add more Champion Series subs in the future.
Add some boom to your daily drive
Is your vehicle's audio system is sounding a little thin? This Pioneer sub can remedy that situation, bringing out all the punch and power in your music by filling in the lowest frequencies of the sound spectrum. Throw one or two of these subs in your daily ride, power them up with a nice amp, and you'll understand what the fuss is all about — whatever you listen to, great bass will make it sound much, much better.
To drive this single subwoofer, we recommend a mono amplifier rated between 260 and 525 watts RMS at 2 ohms. For more information, please refer to our article on How to Match Subwoofers and Amplifiers.
- 10" subwoofer with dual 4-ohm voice coils
- IMPP composite seamless cone
- 2-layer fiber-reinforced elastic polymer surround
- stamped steel basket
- power range: 50-400 watts RMS (200 watts RMS per coil)
- peak power handling: 1,200 watts
- frequency response: 20-250 Hz
- sensitivity: 93 dB
- top-mount depth: 5-9/16"
- sealed box volume: 0.65-1.25 cubic feet
- ported box volume: 0.9-1.50 cubic feet
- grille not included
- warranty: 1 year
- Our 60-day money-back guarantee
- MFR # TS-W261D4
What's in the box:
- One 10" Dual 4-ohm voice coil woofer
- Six 1-1/8" Self-tapping screws
- Adhesive backed foam gasket
- Manual (English/ French/ Spanish/ Portuguese)
- Warranty information
More details on the Pioneer TS-W261D4
Features & specs
|Impedance||2 ohms or 8 ohms|
|Surround Material||Fiber Reinforced Polymer|
|Ideal Sealed Box Volume (cubic feet)||0.8|
|Ideal Ported Box Volume (cubic feet)||1.1|
|Port diameter (inches)||3|
|Port length (inches)||7|
|Dual Voice Coil||Yes|
93 dB at 1 watt |
|Frequency Response||20 - 125 Hz|
|Max RMS Power Handling||350|
|Peak Power Handling (Watts)||1200|
|Top Mount Depth (inches)||5 1/2|
|Bottom Mount Depth (inches)||N/A|
|Cutout Diameter or Length (inches)||9 1/8|
|Parts Warranty||1 Year|
|Labor Warranty||1 Year|
Woofer: The Pioneer Champion series TS-W261D4 features an IMPP (Injection Molded Polypropylene) cone. This process of cone molding assures a uniform cone thickness for superior linearity and clarity. The cone is lightweight and rigid for low distortion and superior bass response.
Surround: The surround is made of dual-layer, fiber reinforced elastic polymer.
Dual 4Ω Voice Coils: This woofer features two 4Ω voice coils that offer wiring flexibility. When the voice coils are wired in parallel, the woofer presents a 2Ω load. When the voice coils are wired in series, the woofer presents an 8Ω load.
Terminals: Both sets of the woofer's spring compression binding post terminals are side-by-side for easy wiring. Each post will accept a pin connector, a single banana plug, or bare wire up to 10-gauge.
Double-stacked Magnet: The woofer uses double-stacked magnets to create a powerful magnetic force. This increases the control exerted over the voice coil.
Sealed Box Volume: The recommended sealed box volume is 0.8 ft³ (from 0.65 ft³ to 1.25 ft³ is acceptable).
Vented Box Volume: The recommended vented box volume is 1.1 ft³ with a 3" diameter x 7" long port (0.9 ft³ to 1.5 ft³ is acceptable).
Single Reflex Bandpass Volume: The recommended bandpass box has a sealed chamber volume of 0.42 ft³ and a ported chamber volume of 2.6 ft³, with a slot port measuring 14-5/8" x 5-7/8" x 11-1/8". Other acceptable designs keep the same sealed chamber size and the ported chamber changes to 2.3 ft³ with a 14-5/8" x 9" x 11-1/8" slot port, or 3.0 ft³ with an 18-1/8" x 3-5/8" x 9-5/8" slot port.
Q Crutchfield asked: Why did you buy this?
3 questions already asked