About the Original Dynamat 10155
Lower the noise and improve the sound of your tunes with Dynamat! Applied to body panels, Original Dynamat reduces noise by 3 dB or more effectively doubling your amplifier power. A good choice for floors and doors, Original Dynamat is an asphalt-based, general purpose damping material. It weighs just .66 pounds per square foot, and is 0.075" thick. With this package, you'll get three sheets (each measuring 32" x 56") of Original Dynamat.
Since your music doesn't have to compete with as much ambient noise, you'll hear subtle musical detail you hadn't heard before. Even if you have your stereo turned off, you'll appreciate the difference Original Dynamat makes. The more Dynamat you install, the more your car will sound and feel like a luxury automobile. If you use a cellular phone while driving, you'll hear your calls much better.
If you are a car audio fanatic who likes your music LOUD, consider Dynamat the foundation of your system. Loud music in a car can induce a lot of vibrations on its own. So your Dynamat does double duty, damping the panel vibrations caused by loud tunes as well as road noise.
Dynamat sheets are easy to cut, so you can apply them in all the odd-shaped nooks and crannies in your vehicle. Warming up Dynamat with a heat gun or hair dryer during installation increases its flexibility and improves its adhesion to the mounting surface. Warranty: 30 days.
What's in the box:
- Three 12.421" Square foot sheets of Original Dynamat
- Installation sheet
- Dynamat sticker
Thanks for submitting your review
More details on the Original Dynamat 10155
Overview: Dynamat is made to absorb the dynamic motion or vibrations found in your vehicle. Dynamat transforms these vibrations into silent energy, resulting in less noise and better stereo performance.
Appearance: Dynamat Original 10155 is a thin, smooth black mat with a blue poly adhesive release backing that comes in three 12 square feet sheets giving you a total of 36 square feet of Dynamat.
Material: Dynamat Original is a styrene-butyadine-rubber-based, pressure-sensitive, adhesive backed, heat bondable vibrational damper material. Dynamat conforms and fuses easily to sheet metal and other hard substrates. Material performance is optimized for temperature rages between 14-degrees and 86-degrees Fahrenheit. The material can withstand temperature extremes between -22-degrees and +350-degrees Fahrenheit and is highly resistant to aging. The material is also resistant to water and mineral oils.
High Tack Permanent Adhesive: The Original Dynamat uses a peel off plastic liner on the back of the Dynamat to adhere to your vehicle. The adhesive backing has a bond strength of 8.6 lbs per inch on cold steel.
Applications: The Dynamat 10155 is designed for general use on rear decks, doors, floorboards and floors of trunks of vehicles to provide more bass, more music, lower road noise and better sound.
dB Gains: Dynamat creates a sonic barrier restoring 3, 6, or even 12 dB of lost dynamic range. By gaining just 3 dB doubles your effective amplifier power.
Installation: Dynamat offers easy installation.
- Clean mounting surface (bare metal)
- Using a razor knife or scissors cut Dynamat to the desired size
- Heating the material before applying is strongly recommended. This will increase the flexibility of the Dynamat and make it adhere more easily to the surface.
- Bend the pad slightly and attach it along its shortest edge
- Apply pressure, working Dynamat into the contours of the vehicle body. This reduces the risk of leaving air pockets, which reduce the sound damping capacity. You can use an optional roller (sold separately) to help provide pressure to smooth the Dynamat out over the desired area.
- Mass: 0.68 lbs per square foot
- Federal Standards Tests: Meets FMVSS 302
The Original Dynamat 10155 replaces these items