About the Niles SPS-6
Add up to 6 pairs of speakers to your system with this handy tabletop speaker selector from Niles Audio. Protection circuitry is built in, so there's a safe operating load for any amplifier or receiver rated up to 100 watts per channel.
Details:- accepts speaker wires up to 14 gauge or pin connectors
- 11-1/4"W x 2"H x 7-1/4"D
- warranty: 10 years
What's in the box:
- Speaker selector
- Manual
- Room labels
Reviews
Customer reviews
Loading reviews...
Thanks for submitting your review
Customer photos
More details on the Niles SPS-6

Product Research
Controls/Connections
- Spring clip connectors in rear accept up to 14 gauge speaker wire
- Push button selector switches for 6 speaker pairs
- Impedance switch on the front panel helps protect amplifier
Specifications
- Construction: black metal chassis padded feet
- 100 watts per channel continuous power handling
- Flat frequency response from 20-20k
- Use 4-8 ohm speakers
Tech Notes:The SPS6 connects all speakers in parallel and the button on the front of the unit adds 3 ohms of resistance to the total load. Ohms law can then be applied to determine the operating load of a given combination. For example: when 4 pairs of 8 ohm speakers are used with this selector's built-in impedance correction circuit, the amp will see a 5 ohm load. If you use 4 pairs of 4 ohm speakers, the total load drops just below 4 ohms. In this case be sure your amplifier can handle a 4 ohm load.
Loading accessories...
Customer Q&A
Loading articles...