About the Terk FM Pro (FM-50)
The FM Pro can be mounted indoors or outdoors, on a rooftop or the side of your house, upstairs in the attic, or on the wall above your audio components it's as versatile as it is powerful. (The sleek, weatherproof housing is even paintable.)
The amplifier is housed inside the antenna and is powered via an included power injector that sends voltage directly through the coaxial cable and into the antenna's amplifier.
For optimum performance, the FM Pro should be mounted horizontally with the front facing the general direction of the broadcast signal.
- amplifier provides +11 dB gain (remotely switchable)
- antenna attaches with 3 mounting screws (included)
- 75-ohm to 75-ohm & 75-ohm to 300-ohm coax to spring clip adapters
- AC adapter
- 58-5/16"W x 4-1/2"H x 1-7/16"D
- warranty: 2 years
- Note: cables not included (see "Accessories")
What's in the box:
- FM-Pro antenna
- 75-75 ohm 75-300 ohm coax to spring clip adapters
- 3 mounting screws
- Power Injector with attached AC adapter (12vDC/100mA output with 6' cable) and coax out and coax in connections
- Instruction sheet
- Promotional literature
Terk FM Pro (FM-50) reviews
Thanks for submitting your review
More details on the Terk FM Pro (FM-50)
FM Signal Boosting:
This unit amplifies FM signals only, the
antenna isn't designed to receive and amplify AM signals.
Weather Resistant: The antenna is made with a co-polymer and resistant to weathering.
Indoor/Outdoor Design: This antenna may be mounted either inside the house or outside, using the three screws provided. For optimum performance, the antenna should be mounted horizontally, with the front facing the general direction of the broadcast signals, and it should be mounted as high as possible.
Mounting Note: The antenna should not be installed on a metal surface since that will degrade reception quality. A ground wire (not included) should be installed to a grounding block (not included).
Simple Operation: The only control is a power on/off switch.
Connections: The Power Injector must be connected to an AC outlet, and the attached coax output cable is made to be connected to your FM tuner (coax to spring clip adapters, which are supplied, may be needed). A 75 ohm coaxial cable (not included) must be run from the coax output of the antenna to the "TO ANTENNA" coax input on the Power Injector.
- Operating Bandwidth: 88 MHz to 108 MHz
- Amplifier gain: +11dB (switchable on/off)
- Input Impedance: 75 Ohms
Q Crutchfield asked: Why did you buy this?
2 questions already asked