Chat
Contact us
Close contact box
Connect ID #
139 271 965 3
Connect ID #
139 271 965 3
All finished with your chat session?

We’ll email you a transcript of this conversation for your records.

All of our representatives are
currently chatting with other customers.

Please enter your name.  
Please enter a valid email address. Why is this required?
Please enter your US phone number.  

For Tech Support, call 1-888-292-2575

Thank you, !
Our conversation will be emailed to

Your Advisor,

More about me
Please enter a question  
Don't wait on hold. We'll call you back when it's your turn to talk with the next available .
Please enter your name  
Please enter your phone number  

Please enter a message  

Calls may be recorded for training and quality control purposes.

We are located in Virginia USA.

MTX RTX2BT

2" bullet tweeter

Item # 236RTX2BT

Concert level highs Are you looking to play your music loud? If so, you'll want to check out MTX's Road Thunder...

Concert level highs Are you looking to play your music loud? If so, you'll want to check out MTX's Road Thunder...

California customers:
Please click here for your Proposition 65 warning.

Item # 236RTX2BT

In stock
$49.95 each

Other options

About the MTX RTX2BT

Concert level highs
Are you looking to play your music loud? If so, you'll want to check out MTX's Road Thunder Extreme speakers, which use PA system technology to bring concert sound levels to your car. If it's time to take your highs to the next level, MTX designed the RTX2BT 2" tweeter with the same compression-horn design found in most concert PA systems, so it'll play at high volumes for extended periods without breaking a sweat. And thanks to its aluminum cone and titanium diaphragm, this incredibly rugged tweeter can handle up to 100 watts RMS. Its 8-ohm impedance means you can wire up two to a single amplifier channel for maximum high-frequency intensity.
Side view of tweeter

Concert level highs
Are you looking to play your music loud? If so, you'll want to check out MTX's Road Thunder Extreme speakers, which use PA system technology to bring concert sound levels to your car. If it's time to take your highs to the next level, MTX designed the RTX2BT 2" tweeter with the same compression-horn design found in most concert PA systems, so it'll play at high volumes for extended periods without breaking a sweat. And thanks to its aluminum cone and titanium diaphragm, this incredibly rugged tweeter can handle up to 100 watts RMS. Its 8-ohm impedance means you can wire up two to a single amplifier channel for maximum high-frequency intensity.

Note: This package contains one tweeter. You'll need an external amplifier to drive this tweeter properly — an in-dash stereo won't have enough power.

READ LESS

Product highlights:

  • 2" aluminum bullet tweeter with compression horn design
  • power range: 25-100 watts RMS (300 watts peak power)
  • frequency response: 3,500-23,700 Hz
  • sensitivity: 94 dB
  • top-mount depth: 2-1/16"
  • warranty: 2 years
  • Our 60-day money-back guarantee
  • MFR # RTX2BT

What's in the box:

  • One 2" Tweeter

Customer reviews

Loading reviews...

MTX RTX2BT reviews

Average review:

10 reviews

Thanks for submitting your review

Filter by rating

Customer photos

Sort reviews

Sort by:
Items per page:
View page:

Verified customer (What's this?)
Verified employee purchase (What's this?)

Pros:

Cons:

Crutchfield response

<< >>

More details on the MTX RTX2BT

Pat M.
The MTX RTX2BT replaces these items:

Product Research

Features

Crossover: A capacitor is soldered to the positive terminal of the tweeter as a first order high-pass crossover. The crossover point using the capacitor is approximately 9 kHz. Optimally, the capacitor should be removed and an electronic crossover used.

Installation: The determining factor of how large the mounting hole needs to be to mount this tweeter is the magnet diameter, which is 2-3/4 inches. However, the wire terminals protrude approximately 3/8 of an inch beyond the magnet, so additional notches in the opening may be necessary.

Loading accessories...

Customer Q&A

8 questions already asked

Q
Will these fit in my 2014 traverse?
[ Nikki  May 14, 2021 ]
1 answer
A
Measure the cone height to make sure it fits below your grill. I have a 2010 Maxima Bose system and it was a little smaller than the original speaker. The grill is raised a little, but nobody can tell except for me. I love cone speakers ever since I purchased my Klipsch LaScalla speakers back in the 80's. I still have those. The MTX tweeter sounds amazing. It's very crisp.
[ KENNETH C  May 14, 2021 ]
Q
Would these sufficiently fit to replace the factory units in the overhead roll bar panel on my 2015 Jeep Wrangler Unlimited with the Alpine Premium system?
[ Robert  Feb 06, 2021 ]
1 answer
A
I do own 2 Jeeps but they are CJ-7's and do have a sound bar in one.....but there are a few styles and yours is a newer model so.....my suggestion is to measure the depth,(because you will need 1.5"to 2" behind the speaker for optimal fidelity), and measure the opening and compare it to the diagonal measurements of the speaker You may need to fabricate something to make it work in the given opening, but the back spacing is a must. the speaker is truly a "component speaker" but I believe it will work well in your desired application. I use mine in conjunction with 6x9 speakers and a 10" sub-woofer and it is in my Dodge Pick-up cab with the tweeters facing the occupants with the sub and 6x9's behind them. I designed and fabricated hardwood boxes for the tweeters.
[ robert  Feb 06, 2021 ]
Q
Will this fit in a Hyundai Accent 2012?
[ Jesus  Jul 06, 2020 ]
1 answer
A
This is really a"component" speaker.......It is meant to be a piece of larger speaker unit.....I guess if you are ok at installation.....it could fit in any hole of the right size and depth.....but what kinda sound is it gonna produce? My recommendation would be if you insist upon using a"bullet tweeter" as a separate speaker, would be to locate the spot where you want the speaker to be. Then make a hardwood enclosure to fit that spot.
[ robert  Jul 06, 2020 ]
Q
Will this be a good fit to replace a blown tweeter in my 2015 4Runner Limited?
[ Ir0nli0nzi0nzbee  Mar 26, 2020 ]
1 answer
A
We have not received any answers from other customers on your question. I would recommend reaching out to an Advisor by phone (1-800-324-9695) or online chat. They should be able to help answer your question.
[ Calvin  Apr 15, 2020 ]  Staff
Q
Will this fit 06 tundra w/ JBL system?
[ Mike  Sep 25, 2019 ]
1 answer
A
This is not a good physical fit for that system nor is it a good choice to run on the stock amp in that system. I recommend contacting an advisor on 1-800-324-9695 to discuss your goals to get a personal recommendation on gear that will work
[ Paul  Oct 09, 2019 ]  Staff
SHOW MORESHOW LESS

Loading articles...

TOP