About the MTX Thunder1
Power in the mix
Power in the mix
Do you like your bass heavy, but your current tweeters can't seem to deliver the high frequencies in that mix? Then take a look at MTX's Thunder1 tweeters. They'll handle up to 90 watts RMS, so you can play them long and hard. Complex sounds like cymbals crashing and upper-range vocals will be reproduced with impressive accuracy, transforming your vehicle's dull soundstage into a vibrant one.
Tweak your tweeters
The Thunder1's discreet design includes a built-in crossover, along with flush- or surface-mounting capability for easy installation in that perfect spot in your vehicle. Plus, you can adjust the tweeters to match up properly with all the other speakers in your installation. And MTX's impressive 5-year prorated warranty makes the Thunder1 tweeters a smart buy.
Installation note: You'll need a pair of our universal backstraps to install these tweeters in the factory locations.
- 1" silk soft dome tweeter with mylar capacitors
- flush- and surface- mounting hardware included
- swivel feature for optimal imaging
- power handling: 10-90 watts RMS (180 watts peak power)
- frequency response: 2500-20,000 Hz
- impedance: 4 ohms
- sensitivity: 90 dB
- flush-mount depth: 3/4"
- warranty: 2 years
- Our 60-day money-back guarantee
- MFR # THUNDER1
What's in the box:
- 2 Tweeters (7" wire attached)
- 2 Crossovers
- 2 Surface mount housings (with tweeters installed)
- 2 Flush mount backing rings
- 2 Flush mount trim rings
- 2 Foam spacers
- 2 Flush mounting clips
- Two M4x35mm machine screws
- Four 3/4" Self-tapping screws
- Cardboard template
- Mounting diagram
- Warranty information
More details on the MTX Thunder1
Features & specs
|Tweeter Design||30mm Dome|
|Parts Warranty||2 Years|
|Labor Warranty||2 Years|
|Sensitivity (1W at 1 meter)||N/A|
|Sensitivity at 2.83 volts||90|
|Frequency Response||2500 - 20k Hz|
|Minimum RMS Wattage||10|
|Maximum RMS Wattage||90|
|Peak Power Handling (Watts)||180|
|Top-mount Depth (Inches)||0 3/4|
|Bottom-mount Depth (Inches)||N/A|
|Cutout Diameter or Length (inches)||2|
Crossovers: The crossover's input and output wires are attached. The 12" output wire has quick slides attached so the tweeter is easily connected. The 60" input wires are terminated with tinned bare wire. The crossover point is 4 kHz and the slope is 18 dB/octave.
- Width: 1-3/8"
- Length: 3-7/8"
- Height: 7/8"
Tweeter Mounting Options: The tweeters can be flush mounted or surface mounted using the included hardware. Once installed in either housing, the tweeter will pivot approximately 15° in any direction.
|Frame Diameter||Cutout Diameter||Mounting Height||Mounting Depth|
|Surface Mount||2.2"||N/A||1.035"||0.64" (Screw Depth)|
Q Crutchfield asked: Why did you buy this?
1 question already asked