About the ATM System 2+2 Cooling Kit
Make sure your high-performance audio/video gear runs cool. The ATM System 2+2 kit features four fans you can install in your media cabinet. The fans are controlled by a remotely mounted tempurature sensor. When your gear gets warm, the sensor activates the fans. If the temperature continues to rise, the sensor increases the fan speeds.
The fans operate with quiet efficiency. They're ideal for mounting in the back of your cabinet to draw warm air out. All connecting wires have plugs — no soldering necessary. And the system comes with its own AC adapter for a power source.
- four 4-3/4" cooling fans with 1/8" mounting plates
- quiet, 23 dBA operation
- airflow: 40-80 CFM (cubic feet per minute)
- 2-speed automatic thermal control with heat sensor
- AC power adapter
- warranty: 5 years
- Our 60-day money-back guarantee
- MFR # 00-202-02
What's in the box:
- 4 Fans (each with attached 5' power harness)
- 4 Fan grilles
- Fan controller module
- AC Power supply with 6' cable (9VDC/1.3A output)
- Thermal probe (attached 43" harness)
- Thermal probe mount with adhesive backing
- One 4" wire-tie
- Installation instructions
ATM System 2+2 Cooling Kit reviews
Thanks for submitting your review
More details on the ATM System 2+2 Cooling Kit
Overview: The ATM System 2+2 Kit fan system is designed to ventilate and cool electronics in large-size installations, such as electronics cases, enclosed shelves, or a home theater equipment cabinet.
Fans: The System 2+2 Kit includes four 120mm (4.75" x 4.75" x 1") 2-speed fans that can be used to either exhaust hot air from an enclosure or feed cool air into it. They can even be configured with two fans feeding cool air in while the other two exhaust it out. If all fans are mounted in the same location, a corresponding vent should also be installed at the opposite end for proper air flow through the enclosure. The fans are capable of maintaining approximately 40-80 CFM (cubic feet per minute) air flow, while generating very little noise. Each fan includes an attached 5' power harness that plugs into the included fan controller module.
Thermo-sensing: An attached thermal probe is included for automatically activating the fan system when the temperature surpasses approximately 85˚F. The probe should be placed over top of the hottest area of the equipment and plugs into the fan controller module, along with both fans. When power is applied to the controller module, the green LED will light. When the temperature gets high enough to activate the fans, the yellow LED on the controller module will light and the fans will run at a moderate speed. If the temperature increases by 5 degrees, the fans will run at full speed and the red LED will light. The fan controller also includes mounting holes for attaching it to the inside or backside of a cabinet or rack space.
- Fan Dimensions (each): Width = 4.75", Height = 4.75", Depth = 1.0"
- Air Flow: 40-80 CFM
- Noise Level: 23dBA
- Thermal Control: Two speeds with automatic activation at approx. 85˚F