About the Dynaudio Evoke 50
Feel a closer connection to your music
Feel a closer connection to your music
Dynaudio speakers convey music's energy and emotion like few other speakers I've heard. Their soundstaging ability — creating a three-dimensional presentation of a musical performance with a solid sense of width, height, and depth — can seem almost magical. Even though the Evoke 50 is a relatively large floor-standing model, when you close your eyes, the speakers vanish, leaving only the music.
Straight out of the box, the Evoke 50 sounds clean, fast, and open. But give it a couple weeks to break in and you'll start to pick up on details you've never noticed before, even in your favorite recordings. Instruments and voices are clearly separated and precisely located within a space that, depending on the recording, may extend from wall to wall and floor to ceiling.
An expanded sweet spot
You don't have to be sitting in the "sweet spot" to enjoy the Evoke 50's expressive performance. Dynaudio employs some of the controlled dispersion technology found in the company's pro studio monitors and flagship home speakers.
By fine-tuning the alignment of the drivers on the front baffle, as well as the crossover design, Dynaudio eliminated some of the sound colorations caused by reflections off the floor and ceiling. This focuses more sound on listeners, even improving off-axis response for those sitting off to the sides.
Dynaudio woofers dig deep
All Dynaudio woofers use the company's ultra-rigid, ultra-lightweight Magnesium Silicate Polymer (MSP) cone material, enabling the woofer to stop and start on a dime. An MSP cone is molded in one geometrically perfect piece, which helps to optimize sound dispersion. It also eliminates the need for a separate dust cap, further enhancing the cone's structural integrity.
This full-range 3-way design starts at the top with a 1-1/8" dome tweeter, and right below that, a 5-1/2" MSP midrange driven by a powerful neodymium magnet. The dual 7" MSP woofers help the Evoke 50 achieve its tight, tuneful bass response.
Dynaudio's new Cerotar tweeter borrows from their best
Dynaudio has been improving and refining its renowned soft-dome tweeters for over 40 years, and the latest version is called Cerotar. Its silk dome has a special coating that improves dispersion while eliminating high-frequency breakup. Dynaudio's engineers borrowed technologies from the tweeter used in the company's cost-no-object Confidence series.
The key component is the Hexis. This ingenious dimpled inner dome sits right behind the soft tweeter diaphragm and reduces unwanted resonances while smoothing out the overall frequency response. The result is sweeter treble and an even greater sense of transparency.
The Evoke 50's cabinet has a large port in the rear to enhance low-frequency output. To help the speaker perform better in a variety of rooms, Dynaudio includes a two-piece foam plug you can insert in the port to adjust bass response. You can actually choose from three levels of tuning: fully open, half-open, and fully closed.
Four stabilizer feet are included, with rubber pads for hard floor surfaces and spikes for carpet. Dynaudio feels that the speaker should not be used without the outrigger feet installed.
With its 4-ohm impedance, the Evoke 50 should be driven with high-current, high-quality amplification.
Build a complete Dynaudio system
A pair of Evoke 50s will produce clear, robust stereo sound. If you're interested in a voice-matched surround sound system, check out these other Dynaudio models:
Center channel: Evoke 25C
Surround speakers: Evoke 10
Powered subwoofer: Sub 3 or Sub 6
- 3-way, 4-driver design
- 1-1/8" Cerotar coated silk soft-dome tweeter
- 5-1/2" Esotec+ MSP (Magnesium Silicate Polymer) cone midrange
- dual 7" Esotec+ MSP (Magnesium Silicate Polymer) cone woofers
- bass-reflex (ported) cabinet with rear-firing port
- includes a foam port plug for adjusting the speaker's low-frequency performance
- frequency response: 35-23,000 Hz (±3dB)
- sensitivity: 87 dB
- impedance: 4 ohms
- maximum amplifier power: 260 watts
- gold-plated binding post speaker terminals
- four cast alloy outrigger stabilizer feet with rubber pads for hard floors and spikes for carpet
- removable magnetic grille
- 12"W x 45-3/4"H x 14-3/4"D (with stabilizer feet)
- weight: 59.3 lbs.
- designed, engineered, and assembled in Denmark
- warranty: 5 years (8 years with registration)
- Our 60-day money-back guarantee
- MFR # 907404
More details on the Dynaudio Evoke 50
Features & specs
|Tweeter Size (inches)||1.1|
|Midrange Size (inches)||5.5|
|Woofer Size (inches)||7|
|Woofer Composition||Magnesium Silicate Polymer|
|Built-in Powered Sub||No|
|Parts Warranty||5Yr (8Yr registered)|
|Labor Warranty||5Yr (8Yr registered)|
|Frequency Response||35-23k Hz|
|Subwoofer Amp Power||---|