PAC SWI-CP2 Steering Wheel Control Adapter

Features

Steering Wheel Control Interface: PAC's ControlPRO SWI-CP2 retains the built-in steering wheel controls in select vehicles when replacing the factory radio with an aftermarket radio. It also allows the retention of rear seat controls (RSC) and retained accessory power (RAP) in select vehicles. The SWI-CP2 is compatible with many of today's most popular vehicles, even with more complex electronic systems including CAN bus, GMLAN, and Class II systems. The simple to use interface module can be configured in multiple ways - via dip switches, direct from a USB connected PC, or a button learning procedure. Wiring and vehicle configuration dip switch settings are provided through the ControlPRO Web-App, or the ControlPRO App for Apple iOS and Android OS.

Vehicle Compatibility: The PAC SWI-CP2 steering wheel control interface is compatible in vehicles equipped with CAN Bus, GMLAN, Class II, LIN Bus, I-Bus, and Analog or Serial Data SWC. Compatible vehicle makes include Acura, Audi, BMW, Buick, Cadillac, Chevrolet, Chrysler, Dodge, Ford, GMC, Harley Davidson, Honda, Hummer, Hyundai, Infiniti, Isuzu, Jaguar, Jeep, Kia, Land Rover, Lexus, Lincoln, Mazda, Mercedes, Mercury, Mini, Mitsubishi, Nissan, Oldsmobile, Pontiac, Porsche, Ram, Saab, Saturn, Scion, Subaru, Suzuki, Toyota, Volkswagen, and Volvo.

Note: The Click here for a complete list of compatible vehicles.

Programming & Configuration: The PAC SWI-CP2 steering wheel control interface offers 3 programming & configuration methods.

• ControlPRO MobileApp: With this method, the SWI-CP2 uses a pre-determined dipswitch configuration to assign the vehicle and SWC button functionality. The dipswitches on the side of the interface must be manually set to the proper configuration by the user. These vehicle specific dipswitch settings can be found by downloading PAC's ControlPRO application (for Apple iOS 9.0+ and Android OS 4.0.3+).
• ControlPRO Web App: With this method, the SWI-CP2 can be connected to your Windows PC in which PAC's ControlPRO Web App assigns the vehicle and SWC button functionality. The dipswitches on the side of the interface must all be set to down/on which is the default position. When using this method, it is not required to manually program the SWC buttons when programming via App mode.
• Manual Programming: With this method the SWC values must be manually programmed into the SWI-CP2 by using the programming button. The vehicle dipswitches on the side of the interface must all be set to the up (off) position. The radio dipswitches must be set to the proper radio configuration (see Instructions). This mode is only compatible in vehicles with both analog SWC and a discrete 12v Accessory wire; vehicles with CAN-Bus buttons cannot be manually programmed.

Two-Function Assignment: The PAC ControlPRO SWI-CP2 allows you to program two radio functions to each SWC button on your steering wheel by using short press/long press dual command functionality.

Retained Accessory Power (RAP): In vehicles equipped with retained accessory power (RAP), the accessory output and the red LED will remain active & keep the radio on for 10 minutes unless the driver side door is opened. In vehicles that do not support RAP, the LED and accessory output will shut off when the key is switched or removed from the ignition.