Everything Works Perfectly

I replaced a Magnadyne M3 unit in the motorhome I bought. Since I have left, right blind spot cameras, and a backup this was my only solution. My previous unit had a 13 din camera plug which I had to separate into three 5 din plugs. Once this unit was wired according to the instructions everything worked perfectly. Now the left and right cameras operator with the turn signals and the back camera is activated with reverse.

Have questions for
?

Saved me money

Worked perfectly for my RV radio/camera replacement. This part gaveme a low cost option hook up all of four of the exterior cameras. Easy setup.

Have questions for
?

Works Perfectly!

Product worked as advertised. I was able to connect my blind spot cameras and they are activated when the blinkers are used and display on my after market head unit

Have questions for
?

the right parts make all the difference

made the assembly super easy.

Have questions for
?

PAC VS41 Camera Switcher

This was so simple to use when i was putting lane change cameras in, tech support helped me locate the wires for the turn signals in my 23 year old vehicle and just tapped into those this thing works great

Have questions for
?

A little pricey..

Using this as a stand alone unit for left and right turn signal cameras I installed. Wiring diagram was straight forward no problems. I do like you can use a negative pulse also . There is a slight delay after the turn signal is off it keeps showing but to me that acceptable. I did try a cheaper one first from Amazon but It had noise in one of the inputs.. this one had none . Solid picture..

Have questions for
?

Not a fan at the moment

This is the second one I have tried, it outputs black and white video from my HD Kenwood Cams. I was able to trigger cameras with it but I didn't see a way to correct the color. Considering the time it takes to install and test I don't think it's worth a third attempt. I learned my Maestro RR2 does the same thing as far as camera switching so I'm configuring that now. The way my stereo is set up 4 inputs only display manual switching options through the radio if they're connected. There are 4 ins and one out with the PAC set up, so the output would need to go to the backup cam input. Any video triggered and displayed from the Pac is shown on the screen but then I lose the ability to change it from the radio, as well as the camera interruption and other camera settings that would be available if all four inputs are connected. It would be better in my opinion if the Pac had 4 ins and 4 outs & displayed in color for all cameras. (If the color issue is a PAC problem)

Have questions for
?

Video Switcher for your RV

This product is great. It solved my problem on my nexus RV upgrade where i had 3 camera (left, right and rear) input to a Sony receiver with one camera input. The PAC VS41 has a trigger out to the radio so that the active input that is being triggered gets displayed. There was no problems with my side cameras being triggered by the flasher (pulsed) input voltage. Do not connect or ground the (-) negative trigger inputs. I did that and had to call Crutchfield tech support (the best) which solved the issue for me. Now my RV has a bluetooth receiver and the cameras all work as desired. Thanks Crutchfield for amazing tech support both in recommending this product and then in resolving my issue when i grounded the negative trigger wires (don't do that). I added an inline 1A Fuse to the PAC VS41 input but that's me. Very happy with this product.

Have questions for
?